Description: The status of this version LED is always on. This series is a four-in-one version of the model, default factory setting is one-way dimming Module size 40mm * 10 * 1.2 (mm), for width> = 10mm of the hard light or other lamps Using a wide voltage work program, the input voltage 9V to 24V can be, Note that the output load voltage is approximately equal to the input voltage Parameters 1. Input voltage: 9v-24v 2. Output voltage: 9v-24v 3. Load power: 30W 4. Load current: 3A 5. Standby current: 10mA 6. Standby power consumption: 0.1w 7. Operating temperature: -20℃~ 65℃ 8. Type: Touch_S (L40W10) 9. Size: 40mm * 10mm (Note: test conditions Vin = 12V) Attention: It is required to install and then power on. If the power supply is installed, may change the environmental parameters, may affect the sensitivity. Touch spring installation, please avoid contact with the electromagnetic signal changes in the complex contacts Try to avoid the use of heavy water for vapor environment, to prevent possible malfunctions. Package Included: 5 * 9V-24V 30W Touch Switch Capacitive Sensors
R**D
Cool little devices for controlling LEDs.
These are great for controlling LED lighting. Wave your hand over them and they turn on. Wave again to turn off. Hold your hand over them once to increase brightness, hold again to decrease brightness. Device will remember what level was set if you turn them off. Device is illuminated with a blue LED at the center of the coil, so I hope you like blue. These are simple devices, there's no way to gang them together so they all come on or go off at once. I used these as hands-free switches for undercabinet LED lighting and while you have to manually turn on each section, they work great. Skeptical wife has been duly impressed and now loves them.
D**D
Great solution for led strips in aluminum extrusion
This was a great solution for my camper, i needed an led light strip, but i did not want to add any external switches. This allows me to dim the led strip or turn it on and off with a touch and as a bonus it is sleek because it fits right into the extrusion along with the led strip.
TrustPilot
3 周前
2 周前
