High quality grinding bits for special use
V**N
Highly recommended
Incredible. I used this to bull nose some granite and after doing over 10 linear metres it's still like new. I did keep water running over it as it cut. It doesn't leave a smooth finish however it gets the right shape in just one pass, going through granite like a hot knife through butter.If you need a smooth finish you'll need buffing pads or sandpaper suitable for graniteTruly incredible value though and very hard wearing
T**R
Did what I needed it to do, but doesn’t last long on stubborn stones!
Bought this stone chamfer bit to tidy up the edges of a concrete worktop. Whilst i wasn’t expecting much from it, concretes being extremely tough, I was very pleasantly surprised at the result!I had about 8lm to grind, and opted for 2 passes taking a bit first, then down to end result and it just about made it before bluntening off!Would definitely recommend, but if you got a lot to do, but more than one!
M**K
Works great
Bought this to router some slate which it did no problem. Couldn't comment on durability on harder stuff.
J**
Cheap but you get what you pay for.
Pretty poor quality. Finished in gold paint that had big blob/run on the shaft. Had to clean the paint off otherwise it wouldn't run true in the collet. Put a satisfactory bevel on some slate. Cut about 3 meters but not much life left in the cutter.
T**T
Five Stars
good
A**R
Five Stars
perfect for the job
