Assembly method: With 12V supply voltage: One cable connects 1, another cable. 2 and 3At 24 V voltage: One cable connects 2, another cable connects 3 (1 remains).Double power supply. Operation with 12 volts or 24 volts. Thinner cables can be used when operating with 24 volts.A central mounting hole on the front for three-point mounting. This is much easier for leveling the bed than for 4-point mounting. First align and secure the side with two holes, then align the side with one hole.Large welding pads for several wires (flat cable) or an SMD connector can be installed. Pads for thermistor SMD 12061 layer of 35 μm copperFEATURE:The 12 volt resistor is between 1.0 and 1.25 ohms (115 ~ 144 watts).The 24 volt resistor is between 4.0 and 5.0 ohms (144 ~ 115 watts).110 degrees Celsius possible for 12 volts as well as for 24 voltsThe 24 volt operation at the 12 volt terminals heats the heating surface to 100 degrees in just 2 minutes (it also consumes up to 576 watts !!)Maximum nominal temperature: 180 degrees CelsiusThe flatness over the surface is approximately within + -0.2 mmMaterial: aluminumSpecial function: contact diode with highback resistance pointFunction: Darlington triodeUse: mixed diodeStructure: NPN Package content: 1 x Mk3 aluminum 3d 3d printer heated bed print bed
TrustPilot
3 周前
1天前
