2pcs 3D Printer Heated Bed Insulation Lightweight Foam Foil 220x220x5mm (8.66x8.66x0.2 inch) Self-Adhesive Insulation Mat Sticker Hotbed Thermal Pad for Ender 3 (220x220x5mm)

I’m sure the insulation pad is amazing. The reviews say so. However that is not what I received. I don’t need a filament holder I can print those lol. The filament holder on the other hand seems to be of decent quality and is adjustable for whatever size so if you are looking for a filament holder this should work. ⭐️⭐️⭐️⭐️⭐️5 for the holder ig lol 😂

The adhesive held on pretty strong, at least long enough to put silicone springs and return to level. The springs are just a block of silicone in a bored cylinder shape and make a nickel coin sized indentation, so the center stays extremely flush in the area between them, but the tips of the corners get tugged off and had to trim a centimeter or two for bed levelling. Not really their fault, if you use normal springs its probably fine. Either way, you get 99% coverage of the pad and the important center is unaffected, so I expect heat to reach the edges faster anyway. Neptune 2s

I have these on 2 different printers:1. Ender 3 Pro with a magnetic Bed2. Labists ET4 with a glass bedBoth printers run the upgraded mean well power supply.On both printers it helped maintain temperatures and heat up the beds faster. Under sustained loads (8hr+ prints), my power reader was reading about 10a~ less here and there which suggests that it lowers power usage which is a big plus to me.For the glass bed it actually stays heated too well so prints do get stuck on it easier, not a big deal to me but to some people it might be.Overall a good cheap upgrade.

This is a great way to stabilize the temperature of your 3D print bed. The adhesion is very good but you should line everything up before you peel off the backing and start sticking it down. It is very adhesive and works well. It keep the print bed more evenly heated and with fewer temperature fluctuations. I hope to update the review with temperature measurements of the bed both before and after installation of the adhesive insulation. However, it works, it is noticeable and it can help you achieve more consistent prints.

The glue is great, so good that it stuck to my fingers and the thin foam tore away from itself and stuck to my fingers. That said my bed heated up mich faster and took about 4 mins longer to cool off. It kept my bed a more uniform temp. Made printing better.

I put the insulation on two of my sender 3 Pros that are modded to higher temps 110c on the bed and 300c on the hotend. Works very well keeping the heat bed hot. I’m able to print better without warping as the bed keeps the temp much more stable using the insulation. The insulation should be a standard on these printers but it’s not.

Ender 3 hotbed insulation, keeps the bed warm for longer which increases cool down times but it also keeps the bed consistently hot through out.

Went on very easily are used a nail to push through so I didn't have to cut it, Insulates my glass bed perfectly. I am now not getting lifting on the edges of my rafts

Produit conforme à l'annonce