TORRAMI Neoprene Rubber Sheet Roll 1/16 (.062) Inch Thick x 12 Inch Wide x 48 Inch Long for DIY Gaskets, Pads, Seals, Crafts, Flooring,Cushioning of Anti-Vibration, Anti-Slip

This is a great rubber backing to use on vinyl Chess mats. It not only lessens the thumping sound of pieces landing on the mat, but also keeps the mat from moving accidentally when sliding the pieces. And, although it’s a little stiffer, it is still easy to roll up for storage or travel. It would have been prefect if they made this material in the size of 24” x 24” x 1/16" square, but using this 12” x 48” x 1/16" works as well. After cutting it in half, I attached the two rubber backings to the back of my vinyl Chess mat as shown using Flex Shot Silicone Rubber and a plastic spatula to spread it around evenly. Then, I allowed the rubber sealant to cure for a full 24 hours where I then used an X-Acto knife to trim the excess rubber at the edges of the mat. Clean up is a little bit of work, but produces great results afterward.

Nice sheet of rubber. Solid and pliable. Just what I needed for cushion between two metal components.

It may be good stuff. I just want to make everybody in my town a rubber doohickey to go under their car battery. Very satisfying. It's just a good thing to have in the garage.

I needed to add mud flaps to a travel trailer. I couldn't find factory made flaps of a size and look that would fit and I would like. I bought this material to make my own. The size was just right to cut the stock in half to make two flaps with just a small bit left over. The neoprene was thick and flexible enough to be just right. There was however a problem. The material is shipped in a tightly rolled coil secured with plastic and it is difficult to get it to lay flat. I have placed weights on it, heated it with a heat gun and clamped it to a flat board with limited sucess in removing the curl. The mud flaps have a curved conture that is less than ideal but usable. I am still working on getting them to hang flat. If you plan to clamp the material between two flat surfaces, making a gasket for example, you won't have a problem. If you expect the material to hang straight, my mud flaps. Be prepared for a fight.

**⭐️⭐️⭐️⭐️⭐️ – “The Swiss Army Knife of Rolled-Up Rubber!”** I bought this 1/8-inch thick, 48-inch long sheet of neoprene for a “small DIY project,” which is exactly what everyone says before they accidentally start a neoprene hobby they can’t explain. When it showed up, it was rolled tighter than my willpower around a plate of nachos. Once I unrolled it, it just sat there on the table, quietly radiating the kind of confidence only a multipurpose sheet of rubber can have. It looked like it could fix a pipe, line a drawer, or turn into a discount Batman mask if things got desperate. The possibilities are endless: ✅ Makes a coaster for every drink in the house at once. ✅ Feels like a wetsuit and a pool noodle had a kid. ✅ Rolls back up into a surprisingly decent pillow if you’re sleeping on the couch for “buying more random materials again.” The only drawback is that every single person who sees it asks, “What’s that for?” and you have to shrug and say, “I’m not sure yet.” Bottom line: it’s a sheet of neoprene, it’s 1/8 inch thick, and somehow it feels like the most useful thing I own. I’ll probably buy another one and not have a plan for that one either.

Worked great for custom splash guards in my Tacoma. A little smelly, so use for outdoor only. Thickness works well for automotive push-pins and resists pull-through if you size the hole correctly.

If you need to make gaskets or vibration isolation, this is what you need. Nice quality, excellent size.

I ordered this to use as a rubber spacer between an aluminum deck plate on the steel framerails of my semi truck, just like the factory does. Aluminum and steel don't mix well and need a spacer to prevent corrosion and this worked perfectly. Exactly as described. Plyable yet strong and doesn't tare but is easily cut with razor knife. The is some smell of rubber, but hey, it's rubber and rubber smells. Comes sealed in air tight package that is pretty tough plastic as I couGld not open it with my hands and had to use a razor knife. Glad I found it as the truck dealers I contacted don't carry this in stock. Will work perfect for my need.

Good flexibilty, yet stiff enough. I had to double the thickness using a special glue. That created a strong chemical bond. The material is relatively easy to cut with a sharp blade.

All good

I used it with screws and fender washers to hold tarp material in place with mostly even pressure (to prevent tearing of the material) so that it would not flap in the wind.

Great quality and worked excellent for the job I needed it for

Worked well for what I had to fix with.