Dorman928-334 Rear Suspension Stabilizer Bar Bushing Kit Compatible with Select Toyota Models

Great value and OEM quality, no mods needed, if you never replaced these before, you need to have vehicle weight on tire to get rear bolt in, I’d removed with tire off but bolt wouldn’t reach with strut extended, drove up a ramp and fell right into place just a fyi

Great fit for an older toyota camry that had the original one rotted out.

Good quality and fit on my 1999 Toyota Solara SLE V6 with no problems.

This did NOT fit my 2000 Toyota Camry and may not fit some Camry's between the year 1997 and 2001. I've requested Amazon to update this page to reflect the inner diameter size of the bushing. Depending on where the Camry was manufactured, bushings will either be 12mm in size or 16mm in size. This particular product has a 12mm inner diameter. My Camry unfortunately had the 16mm size. Still seems to be a good product so I will not deduct stars.

Works great on a 99 Camry. Easy to install. No issues. Been on my camry for years now.

I know there is a note that says 12mm, built in USA. I had to get MOOG bushings from Advance Auto, and just used the brackets and bolts from this kit. Measure your sway bar, 12mm is very small. Apparently my Camry wasn't built in USA? Also the brackets bolt on to suspension where a nut is welded to the back side of a bracket. I I suggest spray liberally with your favorite penetrating spray and let soak. Then apply a little heat before removing. Driver side bolts like to snap, then you have a small job become a half day job. FYI. Take care.

It was a great fit for my 98 Avalon

Perfect PC for my car. The old ones were rotted and made lots of noise. Now it's quiet. Ty