Kanto -S4 Desktop Speaker Stand for Medium Speakers

These are well made and look good, am using them with Klipsch Fives

Très bonne qualité de fabrication, très stable. Parfait pour des enceintes bibliothèque de taille réduite (Edifier R1280DBs pour les miennes)

Buenos soportes para elevar el ángulo de escucha de los Kef lsx II, buena construcción e incluye tornillo para fijar los altavoces.

I own (2) pairs of these for my (2) desk setups. They are fantastic. They are very heavy and sturdy and do not move even when I accidentally pull the cord with my foot. They also do not move when moving my pc stand setup that is on wheels for easy maintenance. If I spin the pc stand around and accidentally pull too hard on the speaker wire it doesn't normally yank the speakers off the desk. I have my sit/stand desks about 20 inches from the wall mounted monitors. There is plenty of space for the speakers to be yanked off into that big opening but it never does. It never does because the stand is made of exotic super metal from space formed in the heart of a dying star and can only be lifted by the worthy (joking but it seems that way). They are not cheap but you get what you pay for. If you want some stands that are: -incredibly durable and sturdy -give you that upward cant, to align the voice coils of the tweeter and mid woofer so sounds of the full audio spectrum reach your ear at the same time (time correction), and reduce sounds bouncing off the desk causing smearing and excessive bass at only a few frequencies overwhelming the fidelity These are what you need. If you have expensive speakers that have active circuitry in them that time align the tweeter and woofer then I have no idea if canting upwards would make your speakers sound worse or not. Either way, these speaker stands are great!

Habe die Kanto S4 für meine Edifier R1280dbs besorgt, die ich als Desktoplautsprecher am PC einsetze. Die Ständer passen perfekt für diese Lautsprecher. Sie machen einen wertigen Eindruck und sind verhältnismäßig schwer. Durch die Beschichtung sitzen die Lautsprecher stabil auf den Ständern, sodass man keine Sorge haben muss, dass die Lautsprecher umfallen könnten. Da die Edifier kein Schraubloch an der Unterseite haben, sind sie nicht mit den beigelegten Schrauben fixiert. Die Ständer werten die Lautsprecher optisch weiter auf und richten sie besser durch den Winkel auf meine Hörposition aus. Ich bin zufrieden und kann die Kanto S4 für Lautsprecher in der Größe sehr empfehlen.

These speaker stands are made extremely well. Construction, look and quality all fantastic. I bought them to adjust the tilt for upfiring Dolby Atmos speakers installed on top of tower speakers. The room where I have my system installed has cathedral ceiling with a flat vaulted-ceiling like portion running in parallel to the main sitting area. No matter what I did I couldn't achieve proper overhead sound because speakers weren't aimed at a flat surface and weren't achieving proper sound reflection. These stands made out of heavy-duty cast aluminum and can absolutely be bent in either direction quite easily if put on the floor and pulled up/down. You need to be careful to avoid bowing the base but you can step on the sides to make sure that only the central section is pulled up/pushed down. Using laser measure to point speaker dynamics, I got the angle I needed to properly point both Dolby Atmos speakers at the flat section. Adjusted ceiling height value in Receiver settings and finally got proper 3D sound with correct overhead channel. These stands are not intended to be adjustable but they a kind of are, if necessary. They are a steal for the price. Look amazing and have proper foam padding on the bottom and on the speaker supporting plate.