SCUBAPRO - Universal Mask Attachment - Compatible with GoPro

I was skeptical but it worked like a charm. Didn’t work on the Solara scubapro mask but it did work on this one. Very tight and secure. I did not have to remove anything on my mask. It’s attached with a zip tie.

Purchased this to record some upcoming dives in the Bahamas. Ordered one because I wasn't sure how it mounted or if it would fit my mask (this one is a Sea Vision color correction mask). I took a couple of pics to hopefully help others with this. It comes with a zip tie and the mount along with some very cryptic instructions that really don't do a lot of good in my opinion. How this works is the there are two tabs protruding from the back of the mount that hit the glass of any double lens mask. These are to be trimmed (easily done with a file or even stout scissors) so that the mount sits vertically on the front of the mask. There is a channel through the mount for the zip tie to go through. The zip tie goes between the skirt and the frame of the mask and also through this channel and is then tightened and cut. This makes the mount quite secure and puts pressure against the tabs on the glass holding it solild and wobble free. My mask had what I'll call a "nose protrusion" in front that I filed down a little bit just for aesthetics sake (I'm a bit of a perfectionist) and so that the zip tie would be used to maximum effectiveness. Overall, the mount is solid as a rock and with the camera mounted it's a stable platform. I am going to buy a few more to put on other masks as well so that I am covered for gopro coverage of the dives, no matter the dive conditions.Hope this helps you a little bit.Sarge

It works good and is east to install but you will have to adjust the zip tie or replace it as time goes on. I found it get slack in it. However it is cool and works for what you need it to do. Much cheaper than a new mask that may not fit you well.

This mount held my GoPro camera securely while I was snorkeling. I have not taken it diving yet. The piece fits all Scubapro dual lens masks because you have to trim some tabs with clippers as part of the installation process. I trimmed my tabs too short, but fortunately the mount is wide enough to be stable on the rim of the mask (to keep from rocking side-to-side). The camera took a great video of snorkeling without me doing anything with the camera (except to turn it on, of course).It surprised me that the mount is connected to the mask using a single, narrow zip tie. Yes, a zip tie. That means I will replace the zip tie after every trip where I dive, to make sure the zip tie doesn't degrade to the point of snapping during a dive. (You don't have to replace it after every dive, just do it at the end of the trip once the trip is finished.) I suggest carrying a small pair of pliers in your gear to help pull the tie thru the holes in the mount, and a small pair of nail clippers to trim off the tie after replacing it. As well as a handful of small ties, of course. These small items easily fit in the case the mask came in. They do not come with the adapter.The zip tie goes between the mask frame and the silicone face seal, so the mask seals to your face the same as it always did. The tie will cause the outer silicone flap to fold over, I suggest you fold it down (instead of up) for appearance reasons.The part is all plastic except for the metal nut that secures the GoPro mount screw. The nut is embedded in the plastic so you don't need to do any special cleaning after diving, just rinse with fresh water.

The media could not be loaded. Overall looks like a good gadget, taking it out on a dive for the first time.Cons: The instructions are non-comprehandible, you are better off gooling videos how to attach it :DPros: easy to adjust. ***** PLEASE MAKE SURE TO TRIM THE LITTLE PLASTIC SIDE TABS IF NEEDED *****The review with video showing the clip wobbling is simply because the buyer did not trim those tabs. Depending on your mask you will need to either cut it off completely or trim it a bit or not at all.Once you secure it with a zip tie and trim the excess of the tie no wobbling or movingOne more thing, when attaching the camera, please make sure the screw goes in from the right side of your face, otherwise it won't hold tight.Post-dive update: the attachment performed well. The camera was secure and didn't move during the dive. I'd actually give it a 4.9 stars, simply because the instructions must be comprehensible.

According to the ScubaPro website, this attachment would fit on a ScubaPro Zoom mask. However, the way you attach it to the mask is via a zip tie (which they included). You also have to cut the tabs on the side to get this to sit centered on the Zoom mask.My wife (who does not dive), said that the whole process of attaching this to a mask seems haphazard and jerry-rigged together and not what she generally sees from how scuba gear is put together.Save your money on this attachment. Totally not worth the $26 I paid to do "arts and crafts" trying to neatly cut the tabs to fit the mask.

I have Hawaii Snorkel Bob prescription snorkel mask and was looking for a way to attach a GoPro camera when I came upon this mount. It installs easy enough with a zip tie and fits snug against the mask. I attached a GoPro Hero 8 and tested with a dry run. It feels like it should work fine in the water. I will be going on a cruise in Feb 2020 and get a chance to try it in the water then.If I have any concerns, it would be with the reliability and replacement of the zip tie. If the zip tie fails, likely the GoPro and the mount will fall to the bottom of the sea. a secondary safety strap would be helpful.Overall, pending my upcoming snorkeling opportunity, I think this should work out quite well.

I bought this mount thinking it was going to replace the center retainer clip on my mask. Not the case. When placed over top it does not sit flush with the Scubapro Zoom mask at all. Not a huge deal if it has to go over it however even with the zip tie fully tightened the mount moved from side to side and there is a gap between the mount and the mask. Might fit other masks better. Do not buy if you have the zoom.