Eono PLA Plus 3D Printer Filament, 1.75mm PLA+ 3D Filament for FDM 3D Printer & 3D Pens, Neatly Wound Filament, Strong and Toughness, Dimensional Accuracy +/- 0.02 mm, 1KG Spool(2.2 LBS), Black

This is my first use of Eono PLA and so far so good.The PLA performed well with good bed adhesion, no horrid smells and a nice shine on the top layer.I checked the PLA weight and dimension and these were spot on.The winding on the reel was not as tidy as some brands but so far no snags on printing.My only negative is the colour is a little flat compared to other PLA brands I use.Perhaps on black, grey etc this is less noticeable but on the red I found it lacked any depth.....wishy!

This pla is as good as other brands. It has good adhesion and the print quality is fine.I will definitely be using this again

Great filament works everytime. will buy again

I am impressed with this filament. I have printed it at the standard settings on my Ender 3 Pro and I have been extremely happy with the results. I got great results at 200C nozzle/60C bed, and the filament has good adhesion to the standard print bed supplied with the printer. Its worked well when I printed some vase mode storage boxes with a thicker line width and I am very pleased with the results. The grey colour is nice and neutral without being too dark. Overall I am impressed enough to have bought three rolls of the filament so far and I can see it being one I want to have ready to go for my printer.

A+++

I've been using this filament for a few projects that need high detail (3d maps). It prints well, nice and easy to get dialled in and I can go back to it at any point and it always prints the same. Printing on a low layer height (0.12) on my Ender 5 I get maps with virtually no visible layer lines. Highly recommended.

Gutted but hope I drew the short straw.The prints started out amazing, which I was super pleased about since I've not used an FDM for over a year (Been using resin printers exclusively since)I bought another FDM and started printing, but came back 5 hours later to see the print failed as the filament was knotted and the extruder couldn't pull more through!Troubleshot my printer and the spool and started again.9 hours later and the same again... the filament was tightly tangled and couldn't separate.I've cut off about 1/6th of the spool at the tangle and hit print again. Hoping it works this time. Will update my review accordingly. If it stays tangle-free I'll likely buy more, otherwise, this brand is a write off forever for me, which is a shame, because the print quality at .2 and 210 hotend, 50 bed is amazing.Fingers Crossed!