DEWHELDrift Emergency Knob Hand E Brake Spin Turn Knob Lock Button Aluminum JDM Compatible with Subaru BRZ Toyota 86 GT86 Scion FRS (Red)

I changed it with my handbrake and ho boy it looks perfect with the interior, just gotta be careful on how you take off the oem one

Works well so far. It feels good, not like the cheep plastic one from the factory.Installing tips:-Put the car into 3rd gear.-Place a 2x4, or peaces of wood wrapped in a cloth between the dash and upper lip of the lockout head.-Use an old drill bit and hammer, to hammer the pin half way out. Getting it started is the hardest part.-Remove the blocks of wood-Hold the leaver to re-leave the strain on the gear box and continue to hammer out the pin until it falls out.-Leave the drill bit in the hole.-Shift into reverse (This stops anything from dropping down once the drill bit is removed)-Remove bit and old lockout.-Install new lockout and old pin (you may need to use the drill bit again to line up the hole with the pin)-tap the pin in a little bit so that nothing falls down and remove the bit.-shift into 3rd and place blocks of wood back like before.-hammer the pin flush with the lockout (use a cloth so to not scratch anything)-use the pointy part of the drill bit this time to punch it in 3-4mm.-install boot use penetrating oil to help it slide over the bottom and a small screw driver.-Install shift knob-done and enjoy.

Product description says that it is for 2013 scion FRS, but it doesn’t fit at all. Shifter hole is too small, and inner part is too short, so it doesn’t even engage the lockout.

the inner diameter of the piece was too small and would not fit at all

don’t waste your time buying this piece of junk

This has a much nicer and chunkier feel to it than the stock button and goes REALLY well with the leather handbrake cover that matches the leather and stitching of the wheel. It simply screws onto a post the old button screws off of. I couldn't get the old one out without mangling it though, bc it's that cheap silver coated soft plastic.BUT I discovered this has a handy hidden security feature. IF you screw it in too far you can't push it in far enough to release the e-brake. So just by giving this a few twists, you can add ANOTHER layer of security against vehicle thieves. And it really would baffle them in the heat of the moment.Beyond being able to screw it in TOO far, you can also choose how much it sits in or sticks out of the handle just by how much you want to screw it on. This does mean that it freely twists if you mess with it while driving around but you can always add some loctite if you MUST have it be still.