ECOTRICTube and Pipe Bender Black Oxide Coating Steel Manual Hand Bender Tubing Tube Bender Pipe Bender Replace for WFB2

I bought this to make it hydraulic and i cant wait to make it hydraulic powered! It is real thick steel.The tolerances on my unit aren’t as bad as some people made it out to seem! I spent another couple hundred on the KAKA die and it worked great.Its worth the money. For reference its a woodward fab copy

First off, the instructions are terrible. However, the bender does work well. I bought the die from maxpeedngrounds and it fits.It will need to be painted as it comes pretty bare bones and will rust quickly if not protected.The handle was quite rusty when it arrived but some sandpaper and paint cured that.The locking collar needed to retapped as the set screw wouldn’t thread in.Overall, little things were wrong but it’s still worth the price.

nice bender a little slopy but does the job

This was the lowest price bender I could find, even after pricing having my own CAD files laser cut. I'm using a die from Kaka Industries. Woodward dies apparently work also. Included hardware is SAE. I'd buy it again.

This machine I bought to replace a tube bender that came from a hot rod shop I was at where it was used well over 20 years.This machine fits Woodward fab does and pro tool dies. Without modifying. Just slap it on.The degree gauge is a little hard to see when bending but you can buy an upgraded one from one of the prior mentioned. It is heavy as my old one which I was expecting thinner material to be used. It has bushings. One of mine got a little damaged during shipment. But I was able to massage and use. Then some of the smaller hardware was lost due to a damaged pretty heavily box which I was pretty concerned about. The instructions were basically shredded in the box due to contents bouncing around loosely. So the packaging could be better. But if you have a picture to look at or someone else’s instructions it’s not hard to figure out. If you need a bender buy this one before it disappears again. I wouldn’t hesitate to buy it 6 more times if I needed

I bought this bender and a die from MaxSpeedingRods. I'm not convinced that the bender is at fault, but the pins didn't fit the die until I opened the hole through it with a drill. Hard to know where the problem is when there isn't a drawing to compare against. Overall I do plan on keeping and modifying the bender. its well built, but the design is a bit mid. As others have noted, the parts tend to flop around. I had no issue however and was able to use it to bend up some tube for a bumper stinger. I think a few small changes could make this a fantastic tool, but for the price point I'm satisfied.

This is a replica of a more expensive tube bender. I'd highly recommend this one over other brands. The quality is identical to other brands.

Product seems like it would be sturdy, the coating on it isn't very even not really a big deal, came with the pins and brass bushings but no nuts and bolts so will have to wait awhile to actually test it