Trustleaf 2kg Tub of Orange Self Indicating Silica Gel, 2-4mm Beads - Dehumidify - Flower Drying - Storage

This is a must have to keep your filament dry when storing it.Easily added to containers and put between spools in storage to maintain dryness.Reusable as you can dry it in the oven, microwave (defrost only) or filament dryer.

This order reveived totally in tact unlike the previous 2kg tub that i am still awaiting a response about

I use those silica gel on my 3d print spools of PLA, works really well and for a long time, since i live in a place with lots of moisture i thought i would have to change every week lol.but with Trustleaf 2kg Orange Self Indicating Silica Gel i can be more than 3 months without changing.My only point is the reuse part can be really trick if you dont use the right setting to dry the gel, because if you go to high you burn than and stop working completely. took me a few tries to understand my oven temperature to dry properly.Will buy again when my runs out.

These work really well to keep my 3D printer filaments dry. The colour change is excellent and tells me when to bake them for recharging (3 hours at 100°c).

I use this stuff on the floor of a couple of large plastic tubs with sealing lids,Inside the tubs i store my reels of 3D printing filament, keeping them dry and ready for use (as i live near the seaside and it's quite humid here)As long as the filament is dry when you put it in the dry box, it will stay dry for years (you can't remove moisture from the filament just with desiccant beads, you need to heat it to drive moisture out... i use a cheap food dehydrator for that)this is my 2nd tub of this stuff, and i've dried some of it once in the oven, followed the directions on the tub and it was fine,My dry boxes sit at about 14% humidity, very slowly climbing after lots and lots of times having the lid removed and replaced to take or put realls in the box.

The media could not be loaded. Big tub, works well so far.

Time will tell. In caravan over the winter

Colour changing, helps a lot.

Ich verwende es um mein 3D-druck-Filament trocken zu lagern.

tres bon produit, fonctionne tres bien a voir dans le temps

Non do 5 stelle solo perché c'è qualche grano irregolare, per il resto rispetta quanto promesso, assorbe e si può rigenerare (gli ho fatto fare 3 giri scongelamento nel microonde) e il costo per kg è il più basso abbia mai trovato.

Pequeñas bolitas de gel de sílice ideales para secar flores. Depende del tamaño de estas tartan m

Utiliser pour garder une faible humidité dans l'ams de mon imprimante 3d bambulab x1c.Fonctionne très bien.Pas encore eu l'occasion de tester la régénération.