Hayve Microscope Arm Stand，Adjustable Metal Bracket with Clamp and Grommet Base，Coin Microscope Mount ，Compatible with Model DM4 DM9 MS2 MS1 MS3& Most 4.3'',7'' Digital Microscopes (1.65（for MS1,MS3)

This things works great for the microscope I have. Nice and sturdy. Not super expensive. Very wide range of motion. Everybody should have one. Highly recommended

I love how this arm allows more freedom of use for my digital microscope. The base that comes with the standard digital microscopes is way too small and restrictive. I had given up using the scope because it's original base made it difficult to get to the circuit I wanted to look at. This allows use anywhere on my workbench!

I purchased this to use with a cheaper end digital microscope with built in screen, after realizing the included stand was more of a limiting factor that initially anticipated. Having the ability to move the microscope around and not just the board, plus working on larger boards, it made sense to get an arm system, and this one fit the bill in almost every way. It has several clamp spots to lock things down when you have the right position, stays where you put it [for now, still early to tell], and had two size options available [check which one you need before ordering]. My only complaint is that there are only 2 screws to lock down the neck of the microscope and the are positioned so they are both on one side. This is not a problem when moving the main arm around or when raising and lowering the scope, but when rotating the head around to get a different angle, I keep finding the microscope will "pop" free of the neck clamp, causing me to have to loosen and then tighten those screws again to get it reseated. If the screws were 180 degrees around each other, or if there were 3 screws evenly spaced, I dont think this would be as big of an issue, but with both screws favoring one side more than the other it leads to this issue even when they are both screwed in. Even with that issue, however, having the ability to move the microscope over a larger board has definitely added value to my budget setup vs the stationary base that my microscope originally came attached to, so I'd you are looking for increased function for not a large investment, this is definitely worth considering, since most budget microscope options come with a small base that may be fine for wires and small project boards, but leave a lot to be desired for larger ones like motherboards.

Its a bit flimsy, but for the price it works plenty well.

This was a great product that I used for a generic electronics microscope. It has long clamp screws to accomodate different sizes of cameras.

I really liked this!! It does its job and it’s much more comfortable:)

Thin aluminum, easily bent just by moving the arm. Later found that sellers are offering the same exact product on AliExpress for $10.

Works great, using it for my 4k microscope. It’s a little bouncy. There may be a way to control it better.

Awesome

Llevo varios meses usandolo, se siente firme y es fácil de ajustar

Super

Ein einfacher und stabiler Arm FÜR Mikroskope. In meinem Fall habe ich das AD407 HDMI 7" LCD-Mikroskop eingespannt. Passt sehr gut und es wackelt nichts.

ESTA BIEN PERO CON EL USO PIERDE UN POCO LA FIJACION