12-Pack 8 Inch Heavy Duty Shelf Brackets, Large Wall Bracket for Floating Shelves, Black Powder-Coated Steel,

I ordered three packages of these brackets and built four shelves, each 11-1/2 feet long, with the brackets fastened at studs on 16” centers. The shelves are made from 1x10 lumber, edge trimmed with 1x2 face frame. They are very sturdy, and the hard powder coat finish on the brackets is attractive. Each package of brackets also comes with a full set of mounting hardware: long and short screws, two types of sheetrock anchors, and even a small bubble level. This is very good value for the money.

Had a pretty heavy piece of scrap wood left over from chopping up my old desk I wanted to use as a shelf for the cat, since she likes to sit with me at the desk, grabbed these to mount it up and voilaIt’s very sturdy and the smaller screws were the perfect size for the piece of woodThe bottom and center most screws can be a bit of a pain to get a good angle on depending on the power drill you have (it was a pain in the ass with mine) because the support arm overlaps those holes, but it’s still manageableThe makeshift shelf I put up is about 40x32inches and weighs around 30lbs, I actually only used 3 of the arms and it’s so stable I actually moved my PC tower (52lbs) on top of it as well and am comfortable with it being up there even with the cat (12lbs) jumping up and down from it

Shelve bracket are heavy duty and able to carry heavy load. Worked great.

Very stable brackets with alternating holes for screws make installation easy. Nice design, paint finish and comes with anchors, screws and a small level.

These brackets are well designed and the powder coating is high quality. The supplied screws are also top notch. However, the countersunk holes for the screws were too small for the screws to pass through properly. As a result, I had to drill out the holes in order to mount the brackets. Perhaps the thickness of the powder coating caused the problem.

Excellent shelf brackets. I used them with two 16” by 4’ shelves and two 16” by 8’ shelves. Shelves are just edge banded 3/4” plywood. Currently just displaying Legos, no issue holding the weight

These brackets and the supplied hardware were of very good quality, however, the detailed instructions for installation of anchors in concrete call for a 15/64" masonry bit. NO WAY...I purchased that bit but the anchors really required a 3/8" bit in order to tap them into concrete... Using the purchased bit I made pilot holes and then enlarged them using bits I already had even resorting to wood drilling bits....No one wants to go back to the hardware store in the middle of a project, so I made it work. Again nice product though

Great product. Well made and sturdy. I bought some cheaper ones and no comparison. These are very good. I will buy them again.