50W LED Exposure Unit Kit UV Screen Printing Light Screen Printing Exposure Unit with Retractable Adjustable Stand for Screen Print Exposing Photo Emulsion Cyanotypes Office

To be clear, this comes as two separate parts: the UV light and a tablet stand to hold it. No instructions but it’s relatively easy to put together. I did end up putting gorilla tape on the clamp of the stand to keep the light extra secure. The clamp alone didn’t feel quite tight enough. All that said, this is great for making cyanotypes! I’m so excited to have this and be able to make cyanotypes without depending on the sun. The light does get hot but I honestly wouldn’t have noticed if I hadn’t read another review that mentioned this. For my purposes, once I had the height set I didn’t need to adjust it again. I do wish the cord was just a bit longer, it’s quite short.

I tried burning two screens . The first did nothing after leaving for 15 minutes and the second did nothing after leaving it twice for half an hour. Don't purchase for screen printing. I'll try it for resin and update review. If it doesn't work will just throw in the trash.

So first off, this lamp gets HOT. Like, concerningly hot, where I'm afraid to use it if I'm not in the same room with it. I also didn't realize the lamp is just a lamp that clips into a generic iPad stand. It's hard to get them to solidly connect because the lamp is thicker than the clamp that's supposed to hold it. Once it's on, it's too hot to reattach bare handed, so you either have to wear gloves or stop your exposure and let it cool down before you can reattach it. I wouldn't buy it again, but it works for now.

I cannot recommend this product unless you absolutely need something for less money. The stand barely holds the light. I have had a couple of times where the lamp fell off the stand onto the project I was trying to cure, completely ruining the project. I smartened up and added a rubber band to hold it on, but really, don't you manufacturers ever test anything you sell or is it only about getting us to spend the money and who give a crap otherwise.

Is fair not to bad.

Poor quality, cheap design, barely held together, light is weak!

It’s a generic tablet holder, that does not get a firm grip on the light. The light falls out. It will work with some modification, and was fairly inexpensive.

This is a joke. It comes with an iPad clamp and a small uv light that is not strong enough to expose my screens.

Stand looks and works good, and about lamp itself i have nothing to say until EU plug will come — would be great to mention Chinese plug in product description

Frustratingly you will need a us to uk plug adaptor. I have not used the product yet, as I now have to order an adaptor. I’m a bit concerned no where on the box does it say the bulb is UV which is what I need. I will update once I have used it.

Great for screen printing but also for curing UV resin quickly

It was not mentioned in the description that it would have a US plug on it. The stand looks good but the light is unusable in the UK, we cannot find an adapter to make it work. Tried to put a uk plug on but the wires are not the same. Disappointing, looks ages to arrive and then un able to use! Can't send back as have cut the plug off now.

The light is useless in Australia without a US adapter - wish this was made clear in the description or an image in the visuals that showed a US region plug. An adapter should have been supplied due to the fact it is for sale on Amazon.com.au, all electrical products should be relevant for the Amazon region that is being supplied the item! Very disappointing with the seller and Amazon.com.au....