Nilight Trailer Tail Light Bar with 3-in-1 Running Stop Turn Signals Brake Lights 2 Pack 9 Inch 100 LED Red & Amber Sequential Strip for Trailers RV Truck Boat Pickup SUV

The product is great but I could not get the wiring to work with 4 pin trailer plug even with the converter.

Works great with 2005 to 2012 Toyota Avalon. I removed the rear bumper to do the wiring and to apply to special black coating to bumper, reinstalled bumper after completing wiring. here is the finished result

Installed these on my 6x14 tandem axle utility trailer. Purchased a junction box with a 7-way connector. I could not get the sequential signals to work because the left signal and left brake were on the same post and right signal and right brake light were on the same post. So there was no way to run the signal wire on the lights without them illuminating when I would apply my brakes. What I ended up doing was running an independent wire from my left trailer light to my left turn signal on my truck and repeated this process on the right side. I used quick disconnects at the tongue and zip tied the wires to my 7-way plug. That way, I can easily connect/disconnect the additional turn signal wires when I'm hooking up my trailer and plugging in my normal 7-way harness. Super bright! I love it!

need a 4 wire system to work, sent back.

These are great lights, but unfortunately you cant use the sequential turn signal on a trailer wire harness. It needs to be built in to the mother board of the light in order to work correctly with trailer wiring. They look great at night and the start up sequence is super cool! I haven't any issues and they've been on my offroad trailer. The hardware is great and the wiring instructions are straight forward.

I put these on my trailer and it always gets attention. People always ask where I got them from and they are very bright. They have a water tight seal and they are easy to install. They work great and they don’t cost a lot

Very Disappointed. I was willing to pay a bit more for the sequential chasing amper turn signal action. Otherwise, I would have just purchased the standard LED stop/tail/turn lights. If you have a standard 4 wire with ground trailer light like most all American small utility trailers and vehicles, the AMBER CHASING TURN SIGNAL INDICATOR WILL NOT WORK. They don't mention that except in FINE PRINT on the instructions. On the standard 4 wire with ground plug, the turn signal and brake light are on the same circuit. The running lights are on a separate circuit. You MUST have a dedicated wire for the left and right turn signal and in most American Vehicles, they are not separated. Very deceitful advertising. The only way the sequential turn signal would work is if you ran a wire from the vehicle turn signal circuit (taping into the vehicle light circuit behind the vehicle light) and ran that wire all the way back to the trailer lights. RIP OFF

Like all the light options! Nice and brite!

2 meses despues de colocarla en el auto, durante la primer lluvia del año, se filtro agua a la lampara y dejobm de funcionar, por supuesto, ya fuera de garantia... terrible

The ones that work, work well...1 of them failed. I missed my opportunity to return/exchange. I will give this a 3 because like I said, the ones I have that are working look great. It would be amazing if this company sent me a working replacement.

Worked great for about month and a half in my vehicle, unfortunately one of the light had died after being installed after a month and driven in the winter. Looks like moisture must of gotten in and shorted it as there is burnt marks on the light. While the other light was connected in parallel, there were no issues with it. Possibly just got a baddly sealed one sadly. Tried contacting the manufacturer/seller with no reply.