Walnut Wood Veneer Edge Banding Preglued 3/4" X 50' Roll

The media could not be loaded.  As you can see from the video that there is a real heavy glue buildup on one Edge and as you try to iron this on the glue will ooze out on to the workpiece which is not good. As we go further down you can see where it disappears and it comes back their spots were glue is completely missing then you'll see where there are shards of the Walnut veneer stuck in the glue also be problematic when you try to iron This. what's sad is this is a replacement roll the first role was defective also and I sent that back and got a replacement and then the replacement is actually worse so I contacted manufacturer when I returned the first one apparenty they didn't bother to Quality Control this thing when they sent the replacement out oh well don't order this garbage. Ive wasted two weeks on this holding up my project.

I refurbed an old beat up round dining room table and needed some walnut edging to match the new top color. This did the trick nicely. Very straightforward to apply with a cheap $10 walmart iron and a scrap piece of wood to press it down (burnish) as it cooled. I didn't see any poor joints, they all blended together nicely. True to advertised width. Finished great with some light sanding and General Finish Arm-R-Seal.

Just what we needed to finish off a piece of walnut plywood for a cabinet top. Very easy to use with a household iron. Sanded well. Took the tinted wax well - matched top perfectly. Couldn't be happier. Just wish it came in a smaller amount. Have a lot left.

It’s exactly what you want from a pre-glued veneer. The finger joints appear to be roughly 6 feet apart. In most cases you will want to cut around them if possible but they aren’t completely obnoxious. I would definitely order more.

Easy to apply with a hot iron. Removed excess with sandpaper wrapped over a sanding block. Applied a few coats of wipe-on poly to seal the wood banding.

Easy to apply, a couple of the strips arrived cracked in the first 2 feet so over buy for your project. It’s veneer I’m not surprised it took a beating during shipping. After the first 2 feet the product has been perfect.

Used this on an American of Martinsville MCM restoration. Worked great. Similar thickness to original. Very easy to apply to straight pieces. I had a curved section that was not as easy but turned out great.

The edge banding is good stuff. I've been working on some cabinets and shelves and used this edge banding to finish off the edges and then I stained the whole thing. It worked like a charm. Also, the preglued feature is great. Some of the edge banding strips had glue that appeared to be a little uneven but that didn't matter. The veneer went right on without any mess.