Dunzy 300 Pieces 1/4 Inch Shelf Pin Sleeves Cabinet Shelf Pins Shelve Reinforcement Grommets for Kitchen Furniture Bookshelf Shelve Support Pegs (Silver)

These sleeves are especially nice when you have already purchased the wrong pins. I bought the 6mm and should have bought the 7mm pins, much cheaper to buy these after that mistake. HOWEVER! The low quality ZUIWAN pins do not all fit into these sleeves (ends are "squished") . The POWERTEC 6mm pins have proven to be a higher quality and all fit smoothly 👌

I read a lot of the reviews that made it sound like these don't work with shelf pins. I ordered the POWERTEC QP1404V 1/4 Inch Shelf Pegs 50pk, L-Shaped Bracket and they worked great. Fit is perfect. If you drill a 1/4 hole these sleeves need to be hammered in to get them tight and they have no play in them.Overall, if you get the right shelf pins and use the right drill bit, these work exactly as intended and make cabinets look much nicer and finished.

Pleasantly surprised. The fit is perfect for 1/4” drilled holes for 1/4” shelf pins.My old shelves had worn 1/4” holes which were allowing pins to move around. Shelves were also unfortunately cut a bit too short. These sleeves fixed the loose fits.These sleeves drive in with a few taps of a hammer, and 1/4” pins(6.35mm) drive into them.The result was a very secure pin!Yes, I would buy again!

While this product worked well it would not accept a 1/4” shelf pin. I hade to buy and use 6mm pins. The of was also greater than 1/4” so I had to use a 17/64 drill into the cabinet. The product worked fine once installed but just wasn’t dimensioned as advertised

Works well and looks great