Igloo Replacment Triple Snap Drain Plug

My old igloo cooler plug wore out. After measuring, this was the perfect size and it works great.

Perfect OEM part. Fast and easy install. Sturdy. Came with all the seals, washers and nut. Exact match for the original. I can't believe I put off fixing my cooler for so long. Great value for the price too. You may need a crescent wrench to remove the old one and install the new one. Large pliers work too but may chew up the plastic nut.

Installed easily and a perfect replacement for the original item on my Legend 54.

Well made and it fits the cooler perfectly. Would purchase again.

I have my grandmother's vintage igloo cooler. It works great other than the drain plug had a crack. I was happy to find that I could just replace the plug instead of buying a new cooler. Easy to remove the old one and replace it with the new one. The cooler lives on to see another day!

I have a 10 year old (?) Igloo Ice Cube cooler. My cooler was designed for a drain spout, but this particular model didn't have one. This deep of a cooler definitely needs one!Took about 10 minutes to install. The instructions had a helpful diagram and measurements of the parts. The small area I drilled through in the cooler is solid plastic, so there was no foam to deal with.- Place plastic nut inside the cooler wall where it would have room to turn/tighten around the spout.- Use a pen/marker to trace inside the hole. In the center of the circle drill a small pilot hole through to the exterior of the cooler.- From the outside I used a spade drill bit to create the hole for the spout (could probably use a hole saw too).- Clean out any left over plastic pieces.- The spout doesn't really have a rubber washer to make a solid seal. Also, I didn't want to tighten it too much since it's all plastic. I used Loctite Clear Silicone Waterproof Sealant (because it was inexpensive) on the parts going through the hole I just drilled. Took about 24 hours to completely set.- Tighten so that it's snug. I made sure to keep the cap cord on top so it wouldn't snag on the ground/surface.Mine is installed probably at the lowest spot while still allowing the plastic nut to turn/tighten inside the cooler. I took it camping last week for several days and it worked flawlessly! I hope the spout/cap last me another 10 years.

Perfect replacement for my circa 2000 cooler's snap cap drain plug. Installation was quick and easy. Instructional diagram is right on the package.

this fit perfectly into my large igloo cooler. stopped the Drip. Drip. Drip. leak from my old scratched up plug.