AsiaHorse COSMIQ 120mm PC RGB Fans Computer Case Fans, 5V 3-PIN Connector Daisy Chain PWM Cooling Fan with Controller for Cases CPU Liquid Coolers

I purchased 6 reversed and 2 normal fans for my Lian-Li O11 Dynamic Evo, have to say that I am very happy with the appearance of the infinity mirror effects and control them with a Nollie 8 using Signalrgb. With layout and inversion tuning in SRGB the result is far better than I expected - color waves and raining effects works great! Also the Nollie will allow for each fan snapped together to be recognized by SRGB, whereas the Gigabyte GCC could not.As this is for a mainly VR gaming PC, noise is minimal in normal use, heavy loads the fans respond very well with the Gigabyte GCC curves I made, so far no issues with heat, maybe see 38*C vrm mos temps so far with the fans set to ~85% with ambient room temps ~ 73*F. I use 2 fans blowing straight up into a 4070S triple fan, the other fans flow from right to left thru a dual fan Deep Cool cooler and exhaust out the back.Overall these fans perform beyond my expectations for appearance, performance and price, especially against the stock Lian Li infinity fans which cost far more. The only difference I see is these fans can't do the "electric current" move as the outside traces are not mapped as independent LEDs. Also Customer Service was very responsive to an issue I had, they communicated overnight at every step of the process and resolved my issue quickly, which would assure me to confidently buy them again.

They look amazing. I couldn’t get them to work at first and I thought they were dead on arrival. I saw other reviews saying the same thing but then I checked the sliding power connection and you have to push it in EXTREMELY hard. I pushed so hard that it hurt my fingers but I finally got them to power on. The airflow is nice, the colors are bright and the click on daisy chain connection made it very easy to install. They aren’t insanely quiet but that could be due to the fan curve I have on them. Overall 10/10 good quality.

The media could not be loaded. These look absolutely fantastic. They are very well thought amour and this makes installation super easy.Pros:1. Look amazing. Very similar to other infinity mirror fans from major vendors.2. ARGB and PWM cables are pass through for easy daisy chaining. NOT just the fans themselves but the feed cables provided are pass through. This allowed me to plug my CPU block ARGB to the end of the chain for example without any needed splitters, etc.3. Kit includes all the cables to use the fans individually or stacked of to three with one cable. I bought two kits of three and used them in a 3 + 2 + 1 configuration as you can see in the pics.4. The price! 62% less expensive than the name brand set of stackable fans I’m returning.5. No proprietary app or controller required. This can’t be understated. I tried a similar set that required an internal USB header connection AND a full time background app. These can simply run right off your motherboard and it’s native RGB control.6. If your MB doesn’t support RGB, no problem, they include a very simpler internal controller that only requires a SATA power connection.7. Pretty quiet, even at full speed.Cons:1. The traditional pin and connector design used to connect the fans to the power feed cables is not as robust as the pogo pin design used by manufacturers at the $90-$130 range. The amount of pressure required to lock the feed cable completely into place was not consistent between fans. I need to go back and press hard to “pop” to of the connectors in place. One connected properly, everything was perfect.2. The rubber bumpers used to thread screws in are a little on the soft side making it possible to strip them if you over tighten.3. Included cables could have been a little longer. Maybe another 6 inches would be perfect. I used one extension to get the rear exhaust fan to reach the port on the bottom of the MB that I wanted to use.

This is actually a fairly nice kit. The build quality is decent and it comes with an optional color/mode controller that you can connect to your case reset button if you don't have an available motherboard A-RGB header. But most importantly they look almost identical to the Lian-Li infinity fans once installed but at like 1/3 of the price. Nice bright colors with 24 addressable LEDs per fan. And they're rather quiet at low RPM.However, these connect using long pins right on the center of the side. They were a bit finicky to chain in the first place where all would get power and fully light up, but after a few tries and switching the order around they worked correctly for me. They do snap together firmly. But if you ever bend any of those pins, due to their location you'll probably never be able to daisy-chain the fans again.Also they're a bit wobbly, as in the center mirror noticeably jiggles a little when they're on. I suspect it's hard to get that tolerance just right in manufacturing plastic parts. It doesn't bother me too much though. These are also fairly loud at high RPM, but that's more a matter of using your BIOS speed controls. I'm glad there's a reverse version but I wish they made a 140mm size too!