Thermal GrizzlyDuronaut - 6 Gram - Enhanced Durability & High Performance Thermal Paste - for Maximum Thermal Conductivity While Overclocking CPU/GPU/PS4/PS5/Xbox

Best performing thermal paste ive ever used, it seems to work extremely well on laptops too. I put some on a 2860qm and a 3687u and suddenly they score in the top 5% of results for that cpu. They both have single core scores over 1800 and my 2860qm is outperforming the average 2960xm with a multicore score over 5200 vs the 2960xm's 4750! You gotta get this stuff for your laptop apart from the 7950 thermal fabric stuff i doubt theres better performing paste for your laptop.Some tips, dont apply it cold, warm it up by rolling it around in your hands if its not at least room temp, DONT USE THE SPATULA always apply a blob on the cpu die and the southbridge die if 0resent and let the heatsink spread it as you tighten it this way you dont get an air bubble, finally use a little more than you normally would i checked the spread on my 9900k and this stuff doesnt spread as far as thinner pastes so you wanna use a touch more.Not counting liquid metal though, dont use that stuff your asking for trouble no matter how careful you are. A laptop board flex's because its a mobile device and when the liquid metal eventually works its way out and onto your heatsink or pcb its only a matter of time before it dies.

The thermal paste is great as always. I highly recommend watching the video to apply the paste since it is much thicker than normal thermal paste and doesn't spread as easily. Performance is great as always.

The paste is good, very good. Just when I thought my system couldn't be any cooler, this paste from TG made my system 5c cooler on avg, min 32c (originally 36c) and max from Cinebench run is 79c (originally 85c). So that's a win.My only gripe is of the new spatula they included. It's a challenge to apply paste with it. I think they should include a spatula angled the other direction (15 to 20 degrees) where the handle is more angled vertically than have the it parallel or horizontal (near 90 degree). I have rather big hands and trying to apply paste with it made it somewhat difficult to use without touching ram or VRMs on board. A spatula with a slight angle would be immensely better to apply the paste, in my opinion!

Thermal Grizzly is the best. I bought one of their carbon fiber pads for my primary machine, works flawlessly. In this case I wanted to protect a Threadripper build which I bought used, as I will be beating on it for a long time. The temperatures are stable and cool despite using a simple air cooler and minimal fans. 10/10.

good so far, no bleedout and better temps than before

I rarely write product reviews but I wanted to give this paste a shot. I usually use MX-6 as my go to. This stuff is horrible to spread. The spatulas are useless and the paste will just stick. I went slow, I applied pressure, I followed their official video. At the end of the process I just made a really big mess and it was even more annoying to clean up. This is putty not paste. I wiped this stuff off and went back to tried and true. Be warned this stuff is a pain to use. The disadvantages of applying this paste far outweighs the benefits of using it.

I have used a lot of Thermal Grizzly thermal pastes and products. I highly recommend them. This is fantastic thermal paste. Give it a whirl, you won't regret it. Highly recommend all of their products.

It is supposed to easier to apply than kryonaut but I had a lot of difficulty. Other than that it’s fantastic. 7965WX sitting at 41° idle and low 70° under stress test in less than ideal cooling conditions.