⚡ Charge smart, record faster—own your workspace vibe!
This 3D printed PLA charging stand for the PLAUD Note Voice Recorder features magnetic pins for hassle-free charging, integrated cable management to keep your desk tidy, and a weighted non-slip base for ultimate stability. Designed and made in the USA, it combines precision craftsmanship with a sleek, compact form to elevate your recording setup.
M**Z
Looks great on my desk
Just wanted to share that the item I ordered has top-notch quality, arrived quickly, and looks fantastic on my desk. A+ all the way!
T**.
Hassle to Use
This is a Plaud stand only. It will not hold up your Plaud unless you your cable is fit perfectly in the slot. I thought it would save me the hassle of dealing with the cable. It only works if you plan on keeping your dock and cable stationary. Design should at least allow the Plaud to stand without the cable attached to it.
J**.
Great idea, unfortunately it requires a sharp bend in the cable.
The media could not be loaded. I really wanted to be able to rate this higher, but the problem is that when you insert your PLAUD Note charging cable, you have to bend it at such a sharp angle that you are sure to be causing damage to the cable.With just a little more room, this would be good enough for most, but requiring the cable to bend that much makes it too risky to use.The plastic that is 3D printed (as well as the non-slip pads) is otherwise nicely done. I wish that it was heavier or weighted so that it didn’t risk flying around a desk when taking off the Plaud Note (you’ll need to hands for this). I also wish it could be designed to use with the Plaud Note sleeve attached, as well as have a better cut out to align the Plaud Note (both in and out of the sleeve).If you don’t mind the bending of the cable and the requirement that you charge it without the case, then this will work. Unfortunately, the cable bend is a dealbreaker for me.Hope this helps!
TrustPilot
2 周前
5天前
