MT200 MTB Hydraulic Disc Brakes Set Left Front 800mm Right Rear 1550mm Mountain Bike Hydraulic Brake Mountain Bike Bicycle Disc Brake 2 Piston

I don’t know much about bike brakes but these say shimano, bled out perfect and stop the bike great. Still consistent after 40 miles. Major upgrade from mechanical disc and a great price. Included pads which again I don’t know about the different ones but these are quiet and stop great for now. Hopefully they last in the long run.

These were bought to replace some garbage Radius brakes that never worked from the moment of buying the bike brand new. These brakes were easy to install and work great. Shimano is a trusted and proven brand and I feel secure that their durability and braking power will last. The fit was perfect and there is no noise upon braking at all.

Perfect right out of the box.

Came packaged well with everything I needed to retrofit to a bike that had cable disk brakes. The piston end of the brakes attaches correctly to the existing shims I mount that was on bike and everything lines up. Breaks come pre bled and assembled so that is easy however for rear brake you may have to disconnect if it needs to be routed through frame like mine was. I disconnected the brake caliper from the brake tube while holding it vertical to minimize loss of mineral oil and taped that end with duct tape. I then fed it through the frame by attaching to the brake lever end of the existing cable and while pulling that cable from the rear the new tube was pulled through the frame. I lost very little oil and once attached the brake had same feel as the front brake that was not disconnected. Took a few rides to bed in to the disk but they are a huge upgrade to my son’s electric crew bike 350. Please be aware and measure the existing cable/tube lengths to make sure these fit!

Pretty solid brakes right off the bat, installed, ran around the block. It's stops good, not top notch but thats just the pads and being that affordable why complain. Does what you need it to, fit perfectly however one of them looked installed and the caliper fully compressed from someone pumping them with out the spacer in.. but thats not the products fault even though I got new I kinda expected new not tried on 'used' Regardless of that I would recommend as now. If there bad you'll see an update, if there good you won't 🤙🏻

They work for a cheap hydraulic brakes good for installing on a bike that you're going to sell they just won't fit an extra large they usually only fit a medium or a small

Perfect fit, pre-bleed, bolt on install rear cable is long enough. Installed on my Schwinn axum comp and ready to roll!

Great product