bestarc Plasma Cutter, Pilot Arc BTC500DP 7th Generation 50Amps Screen Display Dual Voltage 110/220V Digital Plasma Cutting Machine (BTC500DP 7Gen 110/220V)

Es muy bueno considerando el costo del producto, hasta el momento eh cortado placas de 12 mm de espesor sin problema, logicamente a 220 v, es un buen producto, muy recomendable

This plasma cutter cuts 1/2 inch steel without any problems. Works like it should and is easy to set up for any thickness of metal. It is light and cuts what it is advertised to cut easily. Replacement tips are reasonably priced for it too.

الجهاز ممتاز ماشاء الله والبايع جدا متعاون ويرد عليك بسرعه من اول ما ترسل له انصح به

I like the air regulator in the front of the unit making it easy to see and adjust. The water drain and connection at the rear of the machine is nicely protected from being bumped. I like that you can adjust the time the air stays on after making a cut greatly reducing the wear on consumables. The performance is better then a lot of other machines at this price point with a 60% duty cycle at 50 amps 220v but at 35 amps it's 100% duty cycle (60% duty at 35 amps on 110 and 100% duty at 28 amps at 110volt just for info). Lastly when I unpacked the unit, I seen the torch tip was slightly black from them testing the unit prior to packaging. Definitely better quality control then other manufactures I've seen.

I am impressed. I'm running the machine on 110v with a 40 amp breaker, no issues with throwing breakers. A 20 gallon compressor keeps up easily. The thickest material I've cut so far is 1/4 inch mild steel, cuts and pierces with no problems. I run a Hypertherm Powermax 45 at work, on 1/4 inch the only difference is the Bestarc is a bit slower cut speed. And a few thousand dollars cheaper. The build quality is good, not nearly as robust at the Powermax, time will tell how long it will last.