3/4 NPT 110V Hot Water 3-Speed Cast Iron Circulation Pump Circulator Pump

Is working. Thank you

We installed the pump because it took too long for hot water to reach the kitchen and bathroom. It circulates hot water so it takes about 10 seconds for hot water to reach the tap anywhere in the house. Big improvement.

Easy, straight forward installation.......it is as quiet as described...NO LEAKS (I used tape and plumbers putty).Must buy Sensor Valve for it too work, which I did

Use this to clean out my tankless water heater with cleaning venegar, runs for two hrs. Everything seems ok, then shut off and chang to fresh water but the pump have no suction. Unfortunately, my return window passed. Do not buy this if you plan to use it once and through it to the trash.

I installed one of these at the pool house for domestic water circulation. Worked great last year, even though I drained the lines it had a small leak when I filled the water this year. Also it has steel parts and rusts on the water side. Probably should not be used for domestic hot water. Since this is for showers only I night a replacement And will run antifreeze through it this winter or remove it this winter and reinstall next spring. It is inexpensive, quiet, and worked well as a circulation pump for domestic hot water return line.

Update:I use this pump to circulate water through 500ft of 1/2” poly pipe in a homemade solar water heater and even with the pool water 3’ above the pump inlet it has never performed satisfactorily but this year I put this pump on 500ft of 3/4” poly pipe and it is working like a champ. Not sure why it quit pumping in prior review but after inspecting the impeller it is working fine. It’s all cast iron design means it does rust and I take some care when it goes into storage for the windows. As in all these cheaper pumps you must orient them to keep the electric stuff above the pump. The fittings are for garden hose thread but brass adapters are included to convert to 3/4” pipe thread. I think these adapters are NPS rather than NPT but with enough thread sealant they are working for me.Original review:Used about 4 hrs per day for 6 months as circulation pump for solar heater for above ground pool. Never ran dry as about 3ft head on the suction side. Its output has dropped to nearly zero and net head is about 1 ft now so basically useless after only 6 months. Additionally:- input and output threads not well made. Took Teflon tape and extra rubber washers to get tight seal.- impeller mysteriously jammed one time. No debris that I could find. There is a removable plug to grant access to impeller and screwdriver slot on impeller to aid unjamming.- per the directions it is fussy about orientation when operating.- impeller is plastic.

Todo Ok

Great value. Used to replace a failed hot water recirculating pump. Has been installed for a couple of months now and works perfectly with quiet operation.