Side Vent Insert Stripe Decal Sticker

Wider than expected. But otherwise they look good.

I purchased these for my 2012 Camaro. It's a white convertible and these really highlight the white sides. Very easy to apply. I used the "wet" method. Simply spraying the surface with soapy water in a sprayer and also spraying the decals themselves. I used latex type gloves to apply them. Clean the painted surface first. I used alcohol wipes and did each "gill". Then spray the painted surface of the car heavily with the soapy water and apply each decal individually. Use your finger to work out the excess water and soap. Then use a microfiber cloth to dry the whole area. Both these actions are performed slowly and pat the area dry. If you must reposition spray the area again with soapy water and reposition. I left my car sit in the sun for about an hour to make sure they had completely dried. This was very easy and for the money was worth the time and (small) effort to place on the car. I would purchase again.

Nice. 4 stars until 6 months time to see if they hold.

Being somewhat of a perfectionist, I was a little worried about doing it myself. There are two different methods in applying the stickers, either dry or wet. After checking out a couple YouTube videos on how it's done, it was a piece of cake, and it turned out fantastic. The wet method is the only way to go. So far, there still holding up and looking good. The Carmaro's "gills" really need to stand out to give it that cool muscle car loo.

I bought it and was not good, second day on my car and stop working many leds

Find my delivery thank you I love it😻

They're fine for what they are. Just in general the item looks just OK.

Not easy to install but it looks really good when it's finally done. You have to be very careful with it because it's adhesive is so sticky it won't come back off if you lay it wrong. But that's also a good thing because after all this time it's still on there so good!

They look amazing on our car!!

商品説明画像とは違う物が届きました。 説明画像では上下とも綺麗にフィットしていますが、実際の製品は添付画像の通り、下はまあまあ合っているが上側は見ての通りボディのプレスラインと全く合っていません。 製品化の際に実車からしっかり採寸したとは思えない残念な仕上がりです。 このままでは恥ずかしいので、自分でカット調整します。 折りジワも数箇所あり、ヒートガンで温めて伸ばす手間も掛かりました。 全くオススメ出来ない商品です。

Had my camaro painted and these just toped off the job

簡単に貼れますが、油脂をしっかりスプレー等で落とし、1200Wぐらいのドライヤーで風圧を使い伸ばして貼るのがベストです。そうすればOK

شكرا لكم