AKKMX06 2pcs 5G8 90 Degree MMCX to SMA Pigtail FPV Antenna Connector
A**A
Advice
To people complaining that the connector isn't threaded, you do realize that the only function they serve is holding it still DURING tightening. Not to hold it in place at all. Locking nuts and washers already accomplish this, especially once tight. All you gotta do is put the screws in place and it will prevent movement while tightening. Then just remove the screws after. I guess it can be a criticism, but it's a pointless thing to really get upset about as it's function is still fully operable...
T**3
90 Degree For Tight Builds
Good quality. I use them with the TBS Unify Pro HV SE. The 90 degree allows me to bend the antenna around in a loop to fit into my build.
T**L
works perfectly for what they were made for
thick coax makes it a tad bit on the stiff side but allows for excellent signal with extremely little (unnoticed without using a meter) signal loss
B**2
SMA non threaded... poor design
I should have read the reviews first, due to the holes on the SMA connector not threaded??? The whole reason those holes are there is so they can be secured with screws. Horrible design.
C**S
Does the job
Still get great range with my TBS VTx and DJI LHCP pagoda.
T**Y
good as it gets
works great buy them all the time.
M**E
Exactly what i needed.
Works great.
B**.
Holes not threaded
Seriously, why are the holes on the SMA connector not threaded??? The whole reason those holes are there is so they can be secured with screws...
