Tie Down Anchors Retractable Truck Bed Top Side D Ring Compatible with 98-12 Ranger / 98-2014 F150 / 98-2016 F250 & F350 Super Duty -Fit Rear Stake Pockets - 3000 LBS Capacity of 4

Now that I have some time in use of the tiedowns, they are nice! Installing was easy and flush mount is ideal. Providing a good tie down point for cargo in your vehicle.

These fit our truck perfectly. They installed easily and seem like they will support the weight limit as advertised. Also, because they pop down, we were able to install a Velcro tonneau cover over top! (Note: can't use both at the same time.)

I just got these and installed 2 in 5 min,easy installation.They fit perfectly on my truck.They are well manufactured and when tightened down all the way they do not rattle in the bed.These should be standard equipment on the truck.They are very strong.If need instructions,you can follow them: 1. Take off the cover from the truck bed . 2. Loose the screws out off the anchor's base . 3. Put the bottom block into the hole . 4. Lower one side of the stainless bracket, then pried up to snap through the hole . 5. Insert another side into the hole . 6. Put the base on then tighten the screws (pls don't too tighten the screws) .

The tie downs were packed very nicely and fit the openings in the truck bed. The installation was easy just make sure you loosen the philips head screws until the become detached from the blocking clamp. Then pull up on the tie down to seat the clamp and secure the philips head screws. I lubricated the tie down before installing to insure they would retract smoothly. The only thing I don't like is they are hard to bring up in the raised position when in use.

Confusing as to which one to buy, right? So got the ones that said "fit the rear holes", those seem to be the sticking point with some buyers. The rear ones were tight but pushed them thru the holes with a screwdriver and then they tightened up fine. Fronts had a little more room to get into the bed holes. Just angle them, take screws out completely. Nice construction and will work fine.

I'm glad I opted to spend the few extra dollars for the Tigeracing retractable tie downs. They are excellent quality, arrived quickly, and were easy to install. In addition they were 10 times the rated capacity of the plastic block cheap alternatives I reviewed. Not only that, but they look great on my 7.3 Power Stroke.

Excelente

There is nothing weak with these anchors. All metal and easy to install. Stainless steel loop screws anchor plate and nuts. Aluminum base and cap. The aluminum cap has a nice black texture, which I’m sure will get scratched. Nothing plastic to crack or deform. The detent is just enough to keep them deployed and the springs pull them snug and flush when lightly pressed in. They should not chatter. This is a good quality design and build.

احتجت له في تحميل البضائع والمميز فيه القوه والمتانه

Facile a installer, fait comme un gant . 15 min. Installation, enlever les vis du dessus au complet , mettez le en place et re-inserer les vis . Livraison rapide .

Très facile à utiliser très solide

Parts fit, and installation was easy. Have yet to put them to work to tie down a load.

Had a little issue with installing one of them but overall a great product and all stainless steel as described, NO plastic!!! Thank you for your honesty!!!