Lambro 143WP 4 in. Plastic Under Eave Vent

We repair HOA townhomes.What the builder installs is a bunch of junk that allows wasps to go into the vents. I replace those with these.Thank God for stupid builders and lazy subcontractors. I wouldn't make a living if it weren't for them.None of them think these things through.

Works fine. Had to cut circle in a metal soffit, and route exhaust from fan which was somewhat difficult. This was a replacement, the previous similar product deteriorated over ten years from the Florida environment though mounted on the shady side of the home.

The flap opening is ridiculously small and completely inadequate for a 4” diameter dryer vent. You will be intentionally constricting exhaust air flow, if you use this vent (even if the flap door works and stays completely open). Seek an alternative solution.

Need this for a dryer that vents out of my Soffit. Works fine. Easy to install.Great value. Basis plastic with a flap....

Was the same cover that was installed in my house by the construction company that built my house. Easy to replace, but tight fit. The product is not the thickest but the same as the original vent cover on my house. No issues so far.

Our bathroom vents now pass local code, the requirement that the bathrooms vent to the outside.

Mounting hole cracked during installation but was still able to use. Made of thin plastic.

Cheap product not made well