Custom DynamicsMetric Diode Kit GEN-MDK

This item is easy to install and works great and shipping was fast.

I was building a 1980 XV750 cafe racer and I installed this on my bike because i have LED signal lights; however, i no longer had the my OEM cluster which had dedicated signal lamp for each side. For my new mount i wanted one signal warning lamp. Well, when i attempted to connect both signal light wires to the single warning lamp...ding ding ding, you guess it, i connected the circuit and whichever way i signaled my bike looked light i put the hazards on. I installed this between the two front signals and connected the single-wire side to my warning bulb and it works like a dream. now, i only have one LED signal warning lamp and it looks really clean.

The product shipped on time, was exactly what I ordered, and works great!

Nice product works pretty good instructions on how to do it. Basically you cut both wires from the indicator soder the white wire on to one of The wires out of the indicator bulb. Run the other wire out of the bulb into a ground harness. And solder the two red wires onto the other wires you had cut that run to the harness. Easy Peezy pretty straightforward Goldstar well done

This item was needed to eliminate the cross feed after adding Custom Dynamics "Dynamic Ringz" on the front of my 2000 Yamaha Vstar 1100 Classic. The single turn indicator on the speedo is the culprit. I pulled the tank, stripped the wiring harness and soldered this unit in. Instant results after connecting the harness back up and testing before putting everything back together. Everything works as it should. I found this item after going to the FAQ page on Custom Dynamics web page. The lighting is awesome looking, as I installed the "Dynamic Clusters 2" (Stop, Tail, Turn) on the back of my bike. Everything works flawless now. Custom Dynamics stuff is top notch.

Works great. Used on a Honda Ruckus with both front and rear LED turn signal and stock turn indicator.

I have a 99 drifter. Single turn signal indicator. Relplaced all turn signals with LED ones and never had an issue with all lights blinking. Could just be the make/model of bike however.

One of the diodes were defective, I verified the problem with the diode using a multi meter. If you have a solder, I would recommend making your own using a diode kit and some wire.