Legrand - OnQ 20 Inch Cable Management, In-Wall 20-Gauge Media Box, Structured Wiring Enclosure with 2.5 Inch Openings for Wires, Glossy White, EN2000

I always buy legrand outlets and switches because they seem to be made with a good balance of value and quality. This box was perfect for replacing the mess that was my house’s old “network box” which was a hole in the wall with a bundle of cables coming out of it. I also purchased the legrand outlet kit for this box for only $15 which made running power an absolute breeze. The box is dimensionally accurate and with the cover on has a clean aesthetic. I would prefer a hinged door to more easily access the network equipment but for $45 I’m not complaining with the screwed on panel.This was also an unusual install for this panel as the closet was already dry walled. So I used a multi tool to cut a hole in the drywall and then affixed some studs to the edges to mount the box. I wish legrand made a box with a flange on the front that allowed for recessed installs in already finished walls. But affixing studs inside the wall is easy enough with a 14” hole.

A box like this is a necessity if mounting a Samsung Frame TV flush against the wall. It provides the perfect place to house the Samsung One Connect controller for the TV. It fits perfectly between 16”OC wall studs and is attached with screws (not included) screwed into the sides of the studs, unlike some other brands which require additional wallboard removal for face-mounted screw tabs. The cover is optional (we chose not to install it at this time as the TV covers the box).This box is much less expensive than the plastic models from other manufacturers.There are plenty of knockouts for cables and 2 to add metal receptacle boxes for electrical outlets.Note: I removed about a 3” section of the lip at the bottom on one side of the front of the box in order for the One Connect to slide into the box. It took about a minute to remove it using an oscillating tool (a hacksaw or metal cutting blade in a jigsaw would also work). Just make a couple of cuts in the lip then bend the cut section back and forth with pliers to break it off cleanly.

It’s good quality, metal, and sits flush, I was able to place it between both studs and screw it on the sides and it sits flush with the drywall.

Good box for my needs

Good

I bought the 14" box and it fits between 16"OC studs nicely. I also thought that the supplied screws were too large but they are not. You need to use a drill with a phillips bit and use constant pressure on the self tapping screws. The screws are designed to be tight. It takes a minute for them to grab and screw in. Really cleaned up a mess I had in my garage and while I'm installing a new door through brick, decided to clean up the cables.

I put a lot of effort into this project because I wanted the TV to hang just right, perfectly flat against the wall. I found the perfect mount for it. I cut the hole myself and mounted it without any problems. If you're planning to hang a TV, I really suggest using a laser level to make sure everything is straight. It took me a few hours to get all the measurements right so the TV would sit just right against the wall and hide all the wires. LG TVs come with a helpful guide. Between that and the laser level, the installation turned out great, as you can see in my pictures.

Good quality over all, no problem installing it