Corrugated Fuel Hose 5/16" ID x 17-3/4" Long with Stainless Steel Vapor Clamps for In-Tank Use

Seems to be same or very similar to the OEM in tank fuel hose in my 701 Enduro. I used this to eliminate my in tank fuel filter and it's long enough to totally bypass it. Fits nice and snug on all my stock fitting like OEM. Had to use a heat gun on one end to soften it up a bit and it went on fine.

I installed this on the pressure side between the filter and tank outlet fitting on a 2001 Electra Glide. It took major effort to stretch it on, but it worked.

Dropped this into the gas tank of my golf cart that I am rebuilding. So far it's working well. Other gas safe lines were way expensive. This was long enough for what I needed and inexpensive. Time will tell if it's a 5 star.

Watch what kind of hoses you're putting in the tank. Don't trust that trash out there. I used this to route my drain line further back in the tank to keep it away from the intake. Peace of mind with this hose.

Used it for a fuel pick-up line in a 3Gallon boat gas can so it could sit upright in the boat!

Bought to replace my in-tank hose on my 2000 Road glide.Had to use a lighter to soften up the plastic to shove onto the barb fitting/filter because the outer diameter is 5/16, not the inner making the hose very hard to install. Softening the plastic helped wether you use boiling water or heat.

good replacement for the brittle hose from the fuel pump in my 1999 Carrera 2

Nice part! Works well plastic can be shaped to tightly fit the pump nipple