TRANSFER CASE REAR HALF CHAIN BEARING PUMP & SHAFT REBUILD KIT - NV263HD NP263HD

描述

TRANSFER CASE REAR HALF CHAIN BEARING PUMP & SHAFT REBUILD KIT - NV263HD NP263HDIncludes:REAR CASE HALFTRANSFER CASE CHAINBEARING, SEAL & GASKET KITTRANSFER CASE PROTECTOR PLATEOIL PUMP ASSEMBLYMAIN SHAFT*********************REAR CASE HALF - HAS TWO THREADED SENSOR HOLES (CAN BE EASILY PLUGGED WITH BOLT IF NECESSARY) - C30605 - REINFORCED AFTERMARKET CASTING ELIMINATES NEED FOR CASE SAVER ACCESSORIES - INCLUDES PRE-INSTALLED TAILSHAFT BUSHING & OUTPUT SHAFT NEEDLE BEARINGTRANSFER CASE CHAIN (96 PIN 1-1/2" WIDE)BEARING, SEAL & GASKET KITTRANSFER CASE PROTECTOR PLATE - NEWER STYLE CASE SAVER COMPATIBLE WITH OVER THE WHOLE PUMP AND HAS THE CLIPS ATTACHEDOIL PUMP ASSEMBLY - THIS PUMP HAS A BRASS BUSHING (NOT A SEAL) HAS 49 SPLINES AND SPLINE 1-15/16" I.D. USED IN THE 263HD UNITS - USED WITH A 31 SPLINE MAINSHAFT - CASTING 16210 - FOR NON-UPDATED 38 SPLINE PUMP USE #NV16686MAIN SHAFT (LD/HD) 32 SPLINE - FOR USE WITH 4L80E 49 SPLINE PUMP - TO USE WITH A 38 SPLINE SHAFT WITH THE OIL PUMP AND SPEEDO GEAR ON THE SHAFT IN A LD UNIT, YOU MUST CHANGE THE PUMP/SPEEDO/TUBE AND FILTER TO HD PARTS (SPEEDO #NV25902, PUMP #NV25904, OIL TUBE #NV35212 AND FILTER #NV25502) - THERE WERE TWO DIFFERENT SNAP RING SIZES WHERE THE SYNCHRO ASSY RIDES, THIS SHAFT WILL HAVE THE SMALLER CUT, THE SNAP RING TO BE USED IS #NV44716 & YOKE PART #3-3-6421X(1)MG620001 (1)MG10-069 (1)T371R (1)NV-CASESAVER (1)NV25904 (1)NV48714R