KUAT Pivot V2 Swing Away Bike Rack Extension | Durable Adjustable 90 & 120-Degree Swinging Bicycle Hauling 2" Hitch Extender | Car Truck Backdoor Access| Up to 4 Bike/250lbs Capacity - Passenger Side

Just got back from a 1,200 mile trip with a full capacity load. There is really no other way to attach a load to a newer Bronco (mine is a 2022) with the swing open tailgate. Unless you don't intend to get into the back of your Bronco while that load is there! The KUAT Pivot V2 is very high quality and a joy to own. I love the latching feature which will hold it open at a 90° and then an even wider angle if needed. Oh, and it comes in a driver's side swing so it doesn't bang the door which opens to the passenger side. It also arrived very nicely packaged.

This swing away extension is great, worked very well for our campervan to hold bikes with a bike rack. It clicks open at 90degrees then over 90 after that. Very strong, can even stand on it when checking the van roof.Though we must've backed into something as it's slightly off center now, but still usable for the bike rack, but not to attach something to tow perhaps. That's my fault, not of the item, so be careful backing up with this on!

I use this to hold a cargo tray & tool box on the back of our camper van.Its works great. Locks down securely and very easy to swing even when its loaded.It's a bit pricy, But, I think its money well spent on a quality product that should last for years .

I have a Ford Transit Class B camper and I have both a bike rack and a utility rack I use so I am swapping them back and forth. Once you install either of these racks you cannot fully open the back doors of the van. Because of that a swing-arm is necessary. I bought the Kiat pivit 2 because it had already been tested with my Hollywood bike rack and deemed ok by the Hollywood folks. This swing-arm when installed not only comes with its own lock but also an internal tightening mechanism which tightens the hitch internally with the turn of a hex nut. Because two ebikes is a lot of weight on a hitch I added an additional u-bolt where the pieces come together to give it more structure strength. When tightened there is very little bounce with my bikes on the rack. It is nice to release the two locks and swing my bikes all the way out and have full access to the back of the van. Its a great product and necessity for those have Class B vans with doors in the back.

I purchased to use in mounting a Yakima bike carrier to the back of a Sprinter van. The installation was easier than I thought. It included all the tools and the instructions were easily understandable.The build quality matched my high expectations. Both the rack and the included tool.I still wish the latching lever moved down to lock (vs pull up). While if the latch was to release the locking pin holds everything place, I still wish locking the latch was with gravity. A very small quibble. I like the swing away auto locking positions at 90º and 120º.My only other wish is that it was narrow front to back so everything didn't stick out from the back of the vehicle as much. I searched everywhere for something that was narrower and the only product I found was discontinued. The Pivot V2 is not bad - actually it is the best I found, but it could be reduced for my application. I am likely to cut down the hitch post on my Yakima rack as it has excess length for my needs.Happy with the purchase and would comfortably recommend to family and friends.

This is really solid. After figuring out how to tighten it up, it is rock solid. I have a bike rack that connects to this so that I can still access the tailgate door on my Bronco. This works great to move the bike rack forward, to avoid the spare (35" spare) ant it opens wide enough so you can access the tailgate. I'd highly recommend if you have a Bronco. Great quality product.

This hitch is GENIUS! I have a $800 e-bike rack that was no good to me until I found this gem. It’s swings 120 degrees to get the bikes out of the way of the doors. Which allowed me to load/unload 2 more bikes on the inside of the van!! Took me about 7 minutes to install the 5 screws, install the hitch into the receiver, push the pin in and close the key lock. It feels rock solid, looks great, well built. Best purchase I’ve made in years.

This is the perfect answer for anyone who has a ProMaster van, wants to haul something (bike or carrier for extra gear), AND be able to open the back doors! It is so great to be able to open the back doors of my van without having to take my bike off the rack. Well worth the money, extremely, sturdy, and takes about 5 minutes to install the 5 screws that hold the latch.