360-Degree Mini Bar Clamps

These were the correct size to mount some fog lights to the telescopic forks of my motorcycle. The finish looks good and the fastening hardware was very good quality stainless steel. I didn't need the thick rubber spacers -- just the thin double sided foam tape that was included and they fit fine. The adjustability worked great for my application but check carefully to make sure you have room for what you are mounting. The struts that insert into the mounting rings have detents every 45 degrees for the two set screws that secure them. They will rotate freely where ever you need them but the detents in the struts are nice if they line up for your application. The set screws come to a conical point so they will bite into the struts wherever you tighten them down. This was cheaper and better looking than the factory fog light kit that Kawasaki sells through their dealers for the Versys 650.

I had no issue with quality or installing these on my quad rack (3/4 inch tubing) for additional light. These are light duty cast aluminum brackets with rubber inserts that span several tube dimensions. That being said they will strip out easily if apply more force than snug. I did choose to use stainless hardware over the chromed provided. They are a little fussy to to install, be sure to make your rounds when tightening to allow for even clamping pressure.

Great design and build quality, they were super easy to mix and match to fix various bar sizes as needed. Secure and sturdy, 4 stars as getting it setup was a bit difficult with clamping the rubber pieces but overall great.

Worked perfectly for turn signal mount, sturdy, easy to assemble, great look

Perfect to mount PIAA 3" square fog lights on a 2006 GL1800 Goldwing crash bar.

Included clamping screws are way too short to connect the two halves without using a "C" clamp to help push the two ends together enough to get the screws started if you use the included rubber inserts for the correct size mounting surface. Once together, the mount tightens very snuggly and seems to be a very sturdy mount.

The media could not be loaded. The LAMPHUS Off-Road Light Bar Mounts are solid, well-built, and very versatile for use on my Polaris Ranger midsize. Installation was straightforward, with the adjustable clamp sizes making it easy to fit securely around the roll cage. The 360-degree rotation feature is excellent, allowing you to adjust the lights in almost any direction you need. The aluminum construction gives it a durable feel while being lightweight, and it holds up well against tough conditions, even when off-roading. One thing to note is that the provided hardware was a bit limited in terms of bolt length, so I had to source my own bolts for a more customized fit. Overall, it’s a reliable mounting solution that complements the ruggedness of my UTV.

😍