S**N
It failed at it's one job
I bought this extension for my 3D printer port. Didn't want the pins on the printer to wear out with constant insertion and ejection of SD cards.1. When I insert this unit in the printer's port - it's not spring loaded. Have to try 2-3 times before I think it's inserted and don't hear a click. Any touch on the cable and it's out.2. When I finally get the above to work, inserting of sd cards is not recognized by the printer. I have to remove the end in the printer and and then repeat step #1. The whole point of this purchase was to avoid wearing out the printer's pin.A big fail!
L**H
OK if not disturbed
This short extension cable works fine if left alone, but I've had problems with it popping out of the microSD card slot a few times. When plugging cards into the slot directly, they never disengage or feel loose. When this cable is plugged in, I have to make sure nothing pushed it or I lose my connection.Also, it doesn't really matter but it comes in a plain white box as shown in my photo, not the retail box as the vendor shows.
D**V
pretty good adapter
i like the manufacturer's products, and i have been using them for a while. mostly, i was using a microsd to sd adapter, and they work great. i thought i would try the microsd to microsd extension, because something like that can be useful. it works pretty well, but it's a little tough to get the microsd card inserted properly. i figure i will get used to it, but that's why i only gave it four stars.
Y**O
have to remove the adapter from the printer every time
so every time i remove the memory card and replace it, the printer wont read it i have to remove this adapter and then put it back on so it defeat the purpose of what this thing is supposed to do.
T**T
Solid cable
When I wasn't trying to force it into an awkward position (which pulled the male ribbon pins out of contact with the original female connector), it worked exactly as described. Even after I put it through some hell, it still functions perfectly.
M**J
Works like it is supposed too!
While this product does work it did not work for me... I wanted to put it into a Rpi 4 build but the connector is to long to fit behind everything. No way to bend it (slightly) to fit... Again It absolutely does work just not in my application. Give it a try!
"**"
Works great with my 3D printer
I have an Ender 3, 3D printer and I was having trouble inserting the MicroSD card into the slot in front of the printer. Half the time I wound up sliding it above the slot and getting it stuck inside the case. This extension cable allow me to insert the MicroSD card easily and in such a way that I can position is were I have good light and don't lose the MicroSD card in the inside of the printer where is could short out something important. :)
J**K
Does the job
This is simple and does the job it suppose to do. The only thing I don't like is that it's easy to pull out of the machine and have to be careful with it. Maybe use double sided tape or velcro to make sure it don't happen. Besides that, it's a good product.
TrustPilot
2 周前
3 周前