Atomik RC Alloy Front Steering Block, Grey fits The 1/10 Slash and Other Models - Replaces Part 3736

As others have said they are too tight in the steering blocks but I look at this as a positive thing as with a little sanding I can get them to fit perfect with no slop, that's why I got them, just put 400 grit paper on a flat surface and slide them around on the sand paper till you get a perfect fit, definitely took a lot of slop out of my drag car, original plastic ones had a lot of flex and needed shims to take out up and down slop, very happy, bearings fit perfect with no slop, just make sure you line them up evenly before pushing them in, very happy, much cheaper than traxxas.

Was a little wary about getting these Atomik hop-up parts to upgrade my Traxxas Bandit but so far, so good. Definite upgrade over the stock parts. Unless these parts break or get damaged, I don't see a need to upgrade these parts further.

So... the factory steering blocks broke before a single battery run. 5 sets of tires/wheels and 4 battery runs later, the steering blocks are still working phenomenally.

Have not had one bit of trouble since adding them to my car.

did not fit right and i had to do some grinding and overall it just did not work

So far so good, taken many jumps and they've all survived. Added the camber link block as well.

heavey duty

They look good and work well but they do hit on aftermarket aluminum front a arms at full extension but you won’t ever really be at that point ever unless you jump it

much stronger than plastic ones