MATNIKS Solid Neoprene Rubber Sheets Black 6x6-Inch by 1/16 (Pack of 3) for Pipe Insulation Plumbing Gaskets DIY Material Supports Leveling Sealing Bumpers Protection Insulation

Used these sheets for vibration absorption on my crummy Rosewill triple monitor mount. I cut one sheet to match the shape of the mount base where it touches the desk. This has the added benefit of protecting my desk from indentations left by the mount. The mount base has two pieces which fit together using 4 bolts to tighten down, but manufacturing tolerances at Rosewill leave much to be desired. At full tightness, the base pieces still had a bit of wobble. The second rubber sheet solved this issue. Placed in between the top and bottom of the mount (with holes cut appropriately for the bolts to pass through), there is no more wobble. The mount feels clamped down properly and solid. I cut the third sheet to fit on the underside of the desk where the clamps of the grommet mount tighten to the desk. This protects the desk and adds another layer of vibration absorption. While I occasionally still see some monitor wobble when typing, the overall effect has been greatly minimized with this easy, inexpensive fix! Only "con" I can think of is the smell of the product being very strong for a few days but it does dissipate somewhat over time.

I bought this for a completely different reason than it's intended purpose. I bought this to sit on top of the tower fan in our bedroom. We bought a new fan that works great, but the control panel is on top and the controls are constantly lit. I'm a VERY light sleeper and the light on the ceiling drove me crazy. Enter this product. I sat it on top of the fan and presto! The light is gone and with zero disruption to the the fan. Works great, stays put, even while oscillating and I sleep like a baby now! Would buy again in a heartbeat!

Good sheet stock. Hardness and strength as expected. Glossy finish over a slightly textured surface. Not the best esthetically for exposed surface use. Unlike product photo so minus 1 star. Functionally fine for padding, gaskets, etc. like my use in die-cut rounds.

The step boards on my pickup were rattling and driving me crazy! I removed them one bracket at a time and installed cut up portions of this pad to help reduce the rattling noise (also reinforced the mounts with larger fender washers). Now no squeaks or rattles to be heard!

Nice stuff

There's not much to say about this product. It is exactly as it is advertised. Seems to be good quality. However it is apparent to me that this item has been sitting on the Amazon shelf for a long time. On the edges of one of the sheets, it had melted or otherwise "adhered to" one of the other sheets. Probably the result of the three sheets laying on top of each other for a long time. I pulled them apart of course and it left each sheet edge "roughed-up" a bit. Didn't bother me for the project I used it for.

I needed a gasket do the gas tank lid for my 1963 VW. I measured and cut the rubber material to fit inside the lip. It worked perfectly. It was easy to cut, the right thickness and fit the lid so I got a great seal.

Very good for basic gasket material I used it for a friction pad on a rotating bike-repair stand, cut fine with a utility knife, easy to replicate if necessary