Skateboard Truck Rebuild Kit Bushings Washers Pivot Cups for 2 Trucks

Great replacement bushings. My niece had a relatively cheap board from Target which would not turn due to its extremely stiff bushings. After replacing them with these rebuild bushings, the board turns great. Total transformation.My only complaint is that these bushings did nothing in terms of getting her to wear her helmet.Or listen to me in any way at all. Nice kid, but jeez do you really think you are always right? Come on! I've been on this earth 40 years longer than you! Do you think I might have a little more experience than you? At some things, at least? Anyways, good bushings.

These bushings broke and blew out immediately, just as another review mentioned and I chose to ignore.Installed them. Flipped the board over and stood on it to test and adjust the tightness. As I leaned, one of bushings immediately squished and split up the center. (See photo.)Look elsewhere for hard bushings.

I skated a lot back in the day and was quick to say YES when my 10yr old wanted a skateboard. Picked up a cheapy from this site with decent reviews. Bearings weren't great, but that perfect for learning balance. Problem is the cheap trucks never held true and would always lean to one side or the other. They never bounced back. These bushings did the trick. Though I have to take the trucks off (blame the cheapy board), it was pretty easy to install these. 1st try too loose, 2nd try too tight, 3rd try was just right. Not he is really learning and not fighting a board that wants to go in a different direction every time!

This set was intended to rebuild trucks on a Penny board clone. However the pivot cups were too large for the aluminum trucks that are on the skateboard. They however fit a plastic trucks on another skateboard, which was a lucky break. The bushings and the washers are OK and seems to fit just fine.One thing I found is that a piece of clear vinyl tubing from a home improvement store makes great pivot cups. Just take your trucks to the store and find the closest tube that fits. Buy a foot of the tube and you will have a large supply of pivot cups! Cut a piece of the tube and use it instead of the pivot cup.So make sure that the set fits your trucks before ordering.

I want my money back these are not good at all. I would return then but I had to use HALF of the set and Half of my old set to get it to fit on the king pin. If I used both bushing from this set there is no way to get the nut on the king pin. Im ticked off. Wasted money. I WOULD return this junk but I needed to ride my board when these arrived so had to make due. Cheap stuff.

I have no issue with TGM and buy several products from them however this bushing set was crap. They split and started blowing out on the first day. I had the trucks very loose and did nothing more than carving, powerslides and Bert slides. I let a small child ride my board for most of the time. Next time I'll just get more shorty 100a if I change trucks again for a different size setup.

Great rebuild kit for gullwings trucks. I replaced my 37 year old skateboard clouds and back on the board again. Highly recommend

Seller - 5*Dime Bag Bushings ...The bushings lasted 5 minutes before one of the top cones split. This isn't normal - these bushings are neither "store brand" nor cheap.The green matches Powell's lime green boards and green wheels pretty well ... if that's your end game.It isn't a seller issue (unless they are shipping old product) but a case of a good company's name on a bad product .This seller offers many alternatives - spend the same money on a set with better ratings.