Siloxa-Tek 8500 Ultra Concentrate - 1 Gallon (Makes 5 GALLONS) Penetrating Concrete Sealer Water and Salt Repellent. Clear Water-Based DOT Approved Silane/Siloxane for Concrete Brick Masonry & Pavers

Used to treat a large stone chimney that was soaking in so much water that the inside mantle was after moist to the touch. Now the water beads off and I haven't had moisture inside since. It was simple and easy to spray on. It's been 6 months and so far it's holding up well.

Summary: this is a great product, worth the effort and expense if you need to protect your concrete from chemical exposure or water absorpsion.It's easy to apply by a pump up sprayer, brush, roller, sponge, or whatever you prefer. I had some puddling of the product, from over application, and a broom worked great for redistribution.For my new, 4 month old, broom finished concrete, it took substantially less product than the general recommendation. Note that it does state 'porosity' of what your applying it to is the main factor regarding coverage rate. i.e. your mileage will vary!It's important to follow the directions and apply a second coat while the first coat is still wet. More on that below. Naturally, the second coat required less product than the first.I can barely see a difference in the look of my concrete after application... until it's wet, which causes beading and considerable resistance to absorpsion.I treated another concrete pad the following day and sprayed some of the leftover product on a small portion of the previously treated concrete (pool deck) and immediately noticed puddling and lack of absorpsion.Only time will tell how long the protection will last for my pool deck. If I get 5+ years before needing to reapply, then it's well worth it.

I sprayed Ghostshield on the floor of my brand new shop.I thought the product was a little pricey UNTIL I USED IT!Ghostshield was SOOOO easy to use, spread just like the instructions said it would, and was too easy to clean up, since it's water based.I could not have been more pleased at the results. Liquids bead up on the floor like mercury. It did not change the appearance of my nice new floor at all. I even sprayed it on my new wooden baseboards. Did not change their appearance.I have been telling my friends about it. I LOVE IT!

It was easy to apply and water beads off the concrete so it is well sealed

It was purchased to seal an existing concrete driveway after power washing all the dirt and grime off it. I had originally planned to use a sprayer to apply Ghostshield 8500 but used a paint roller instead, due to it being windy on application day. I purchased the 1 gal concentrate and mixed with 4 gal of distilled water per the manufactures recommendation. The product mixed easily with the distilled water and was easy to apply using a roller (just a longer process than spraying). It has not discolored the drive nor made it slippery. It has rained a few times since I applied it and the water is definitely not penetrating. As for how long it lasts that remains to be seen as it has only been on for two weeks.

This product works!!!!! It works on concrete and stone. Period end!!! We put this on our Tennessee field stone coping around our pool. Our issue was the fieldstone will flake off if water gets under the layers. I wish I knew that before using it as coping around my pool. We used the stone on the fireplace which is on the patio as well to match. Anyways, the water just beads up like the picture shows. This is about 9 months later so I can not attest to the longevity of it but here is the deal. I got a gallon of the concentrated stuff to make 5 gallons. I mixed it in a 5 gallon bucket from Lowes. I did three coats around a 18 x 36 pool and a hot tub and I still have 4 gallons left. I used a paint roller and my wife got in the Pool and put the stuff on the edges. We used a big container lid in the Pool to catch the drippings that fell. No question it was a 2 person job for a pool. Now the down side is....we were not quite as detailed on the edges on the concrete.......well it works there too! You do notice the color difference on the concrete when it rains....it's whiter. But zero difference when it's not wet. BTW no color difference on the stone at all. However be sure not allow it to dry between coats. It will give a cloudy look to the stone dry or wet.If you want to seal stone or concrete. This is the stuff!!!!

VERY simple to apply, and dries quickly.After power-washing, I resealed a 5-yr old driveway & front walk. I used the gallon concentrate (makes 5-gal) and it was really easy to mix. I planned to use standard garden sprayer (which would have been perfect for the viscosity of Ghostshield 8500) but I chose to use a roller to prevent overspray. Directions say 5-gal will cover 1,200 square feet with 2 coats applied as directed. I found this to be pretty accurate.I just applied yesterday and it hasn't rained yet, so I can't rate the water resistence or longetivity yet.However, I can add one add'l comment...Though it appears to dry quickly, Ghostshield recommends protecting application from rain for 24 hrs. In either case, when it appears dry, there's absolutely no change to the color or appearance of the concrete; a great result, since we like the original appearance didn't want it to darken after sealing. Ghostshield truly lives up to it's name.Also, worried about applying Ghostshield and having leaves stick to the concrete? (Like it or not, it's that time of year again.) Well, don't be! Ghostshield penetrates pores of the concrete to seal, it's not a sticky top-coat.

easy to mix. we used a battery operated sprayer. we had to use 4 gallons to do a pool deck, carport and some landscaping bricks. repels water great. had a company give us a quote that was going to charge us $12,000 and they were going to use this product. they were going to do some grinding and a little more work around the pool deck, but I thought we would try this to help seal the deck on a lower budget. so far it seems to be working good.