Neoprene Self-Adhesive Rubber Strip for DIY Gaskets, Crafts, Pads, Seals, Warehouse Flooring - Solid Sheet Roll With Adhesive Backing (1" Wide x 1/8" Thick x 10' Long)

Very nice product. Sturdy and the adhesive is nice and adheres well. Use it in the base of a lanai door that was neede to be replaced

Adhesive is super sticky, and the strip is easy to work with. It lays down quick and easy and follows slight curves without buckling. I used it to replace worn and rotted factory rubber at the bottom of my Expedition windshield and with how well it worked there I’m going to use it at the top of my Charger windshield for an added seal and to give it a finished look. The double sided tape will not hurt the paint if it ever has to be removed for some reason. A little bit of WD-40 or goo gone and what’s left over from the double sided tape will be gone.

I wanted this to put between a newly painted steel trailer frame and a fiberglass camper shell that sits on that frame. It went on easily. Cuts to length with good scissors. Seems to be the right compromise of softness for cushioning and firmness for durability. The adhesive is good. I had to remove one small piece due to an error in my part. It was hard to remove but doable, and no damage to the paint underneath. Very pleased overall.

When I hear "neoprene" i expect wet-suit type, flexible rubber. This rubber is hard, dense, and unless warmed up, inflexible. The glue is really strong. I bought it to pad the PVC pipes under my house, to protect my head from the inevitable bumps. This is better than the bare PVC, particularly at the joints, but I was expecting something softer. It is easy to apply, but needs some support on curved surfaces to keep it from uncurling.

the adhesive , while quite sticky is more of a mastic and will slowly flow or slip with sideways force. if you are applying this where the force is straight down between the two surfaces this will be fine. If your application involve some shear force between the two surfaces the mastic will slowly slip. My use for this was to give better grip between a round clamp and a lighting truss. The mastic caused the clamp to slip around the truss pipe. My solution was to roll the mastic off of the neoprene and then use CyanoAcrylate to glue the neoprene to the clamp... now it works as intended, no slipping of the clamp and no marring of the truss.

So far this product is working like a charm….

Great product

Strong rubber backed by a pretty gelatinous adhesive, might work depending on your application. I'm using it as a liner on a power rack, which has a lot of focused pressure from the barbells, which tends to cause it to slide. If your application is more disperse, it's probably fine.