KOYOFEI5PCS Screen Protector for LCD Resin 3D Printers, Screen Protective Film for Elegoo Saturn, Photon Mono X, Voxelab Proxima 8.9 inch Monochrome LCD Resin 3D Printers

The quality of these screens if great they fit easily on a anycubic photon mono 2. Easy to remove if any resin is spilled too.

Well packaged and was a 100% replacement for the original

I ordered these for my Saturn 2 Printer, and though they are the right length they are no where near wide enough, I expect a screen protector to protect the whole screen not just 80% of it! :-( not impressed.

have been using this brand of fep sheet for a few years now.My printers are in use nearly 24/7 and the fep sheets have any issues, im getting several months out of each sheet. Tbh would probably get more use out of them if i was a bit more gentle cleaning failed prints.I've also been using one Fep sheet as a screen protector and ive had no issues with quality, ive turned the uv brightness down to 90% as well so the printers will last a little longer and still no drop in print quality the sheets must be super clear.

Screen protector fit the 3d printer perfectly. I got the pack of 5, 9.1 inchs. Happy I now have spares. I Will order again when needed

For a resin printer. Does the job.

Pretty good, saved my screen a few times

Saturn 3 ultra user. Like a few others have said. It will reach across but won’t cover the length/depth

I finally go around to installing these 'screen protectors' and they are useless. They don't even go past the tape that is around the LCD screen- so how is it supposed to protect against spills?? I expected these to run well past the edge of the tape to where the edges of the vat sat on it.Nope.You are better off buying plain acetate for $.25 cents a sheet and cutting it down yourself.

These are easy to install and make mistakes of resin tray leakage a worry of the past! Unfortunately, if you mess up the application you have to start over, but if you follow the instructions it's easy as can be.

Llegaron rápido

The screen protector looks like a typical screen protector and I'm not so certain this is the fault of the screen protector at all. It is slightly larger than the screen so it overlaps onto the plastic of the printer which at first I was happy about because that means that seem would be protected of a spill but the trouble is is that plastic is a little higher up than the screen not allowing the screen protector to sit flat on the screen around the edges. You can see around the edges the screen protector does not lie flat. Everything about the product is fine but I'm not so certain it's designed for the Mars 4 Ultra

Great.