GI Replacement Brass Ceramic Disc Tap Valve Insert Gland Cartridge Quarter Turn

The best way to replace these is to take an old one out and check you are getting the right sized ones. Makes sure your water is isolated then turn the tap on to make sure. The turny bit on your tap will have a cover over the screw to remove it, probably a hex key. Remove the turny bit from the tap then screw out the cartridge with the correct size spanner. Match it up, measure it to be sure. The quality was as expected and cheap enough to buy. Re fitted easily and no leaks.

I bought this to fit to an old Cooke and Lewis mixer tap with a leaking hot tap. It fitted fine and stopped the leak which is great certainly a cheaper and easier option than changing the entire mixer tap. I only had one small issue and that was that the original cartridge has a slightly shorter spine shaft that the tap lever fits on, so it felt a bit loose. I solved this by adding a washer onto the shaft so that when the screw was tightened the hot tap lever felt secure. It works well and was a decent price and it proved to be a very easy job to do . . . . I have given this 4 stars not 5 only because I had to tweak it with the addition of the washer.

After isolating the water supply, l removed the old valve, smeared a touch of silicone grease on the threads of the new valve and screwed it in and tightened it up. (Before I undid the old valve, I did make a wooden template with cutouts to hold onto the tap spouts to stop them moving when using the wrench to undo and refit the valves)

Fitted great and stopped leaking kitchen tap

Installed on my taps, worked as expected

It has fewer splines on the top bit than Franke taps. I should have checked, but assumed, as it was second on the search results, it would be standard ☹️

The valve fitted well with no leaks and the splines matched the handle. However, the supplied screws were too short, so the old corroded screws had to be used again. Otherwise, a good quality valve.

Simple to fit and perfect thread and collar sizes

Acheté pour remplacer les têtes d'un robinet Squash de Jacob Delafon vieux de 30 ans (chrome toujours en parfait état). Les têtes se montent facilement et s'ouvrent dans le bon sens : les 2 vers l'arrière. Les croisillons se montent bien mais l'extrémité crantée de ces têtes est plus courte et l'épaulement plus long que sur celles d'origine. Résultat, les croisillons sont un peu écartés (3-4 mm) du corps du robinet. C'est plus esthétique que fonctionnel. À l'usage, après quelques mois, les robinets restent bien doux à l’ouverture et ne produisent pas de bruit d'écoulement.

Perfect replacement, works like new.

Pas de problème pour le montage

j'ai reçu ces 2 têtes de robinet, le lendemain de la commande. Je les ai installés de suite et ils vont parfaitement sur les robinets de ma cuisine. Je recommande ces produits.

acheté pour remplacementsur robinetterie de cuisine montage sans probleme usinage tres correct a voir sure le long terme sinon fait tres bien le job