Intex 59631NP Pool reparatiepleisters - 6 stuks - transparant - 19 x 15 x 13 cm,transparant

Our above ground Intex pool suffered damage over the winter and I didn’t realise until it was half full. The pool had a 10cm slash which had not cut through the liner but was bad enough to allow water to leak out at quite a rate. We let out enough water so that it was well below the damage, and once it was dry I applied a patch inside and out. We left it to dry before continuing to fill and it has preformed very well, and it is now been in place for a couple of months and I am very happy with the repair.The pool also developed a single pin prick hole whilst it was filled with water and I managed to apply a patch to the outside. The water pouring out and it was tricky to apply the patch as there was a lot of water and it was impossible get it really dry, but we did manage to get it to stick and a couple of months on it is still holding well. I will replace this once the pool is empty but it has been a good repair for the season.

Please with.product

great

Even if I followed the instructions and applied on a very clean surface it last only for couple night. I tried it three times and the air bed lost air every time. Not as good as expected.

Works perfectly after a little nick in our pool, the first set we ordered came through wet so couldn't use and had to wait another week for another delivery but worth it in the end

Bought to repair a small hole on an Intex inflatable paddling pool. The patch went on with ease (opted to use a whole patch for belt-and-braces, just rounded the corners to help prevent getting snagged) and initially appeared to stick well and subsequently maintain inflation. However, it failed a couple of usages later with the patch just easily peeling away. Not sure why the adhesive seemingly failed, particularly given that both the pool and the patches were from Intex and so I wouldn't expect a material incompatibility. Worth a shot for a couple of quid but am now looking for a more permanent repair - might try a separate adhesive+patch combination.

Great value for money at only £2 for a pack of six. Bought to repair our blow up swimming pool and blow up swimming rings which both suffered a small puncture. Once I had finally located the hole these patches were straight on to plug the hole. After 30minutes re-inflated and now staying inflated thanks to these great patches.

These patches did not work very well at all. The hole in my tub was a 5mm slit and was clear of any seams. It was cleaned up with an alcohol wipe. The patch was placed over the hole and left for over an hour before re-inflating the tub. Within three hours it had gone down again. I removed the patch and tried again this time not using the alcohol wipe but a solution of soapy water and dried it thoroughly. Placed a new patch over the hole and waited another hour before re-inflation. This time the tub stayed up for a day , but still went down. 🤬

Les doy un tip no lo sabía jaja el parche se puede cortar y solo utilizar lo necesario para el orificio yo lo usé en un inflable para patear y excelente!!! Y en fugas de agua también

Worked well and good price

Ok

les rustines sont très résistantes.Posés sur une structure gonflable et ca ne bouge pas.Je recommande++

Je recommande