16Pcs Mini 2 Propellers Replacement Low-Noise and Quick-Release Blades Props Compatible with DJI Mini 2 / Mini SE/Mini 2 SE/Mini 4K Drone, Silver

لم احبه سي التطابق غير صحيح

I’ve done 2 test flights of these. So far so good. Do seem to be a bit lower noise. Screws come pre-coated with thread locker

If you are flying an e88 clone "mini" foldable quadcopter of the dirt cheap flavor; then these props may bring your drone to life. For me, it was the TTROARDS 19LCD; the propellers they ship are quite thin and brittle. After going through several replacements learning how to not crash (or how to crash better) I ordered these at a risk. They are much thicker and stiffer than the props they replaced. With the combination of my ability increasing, and the addition of these propellers; I haven't had to replace any since putting these on. The lift and maneuvering is much more acceptable. The drone is finally somewhat enjoyable to fly and have control.

Durability wise they are about as strong as the original blades , I’m still on my first set .

Title says it. I bought these just to test on my new potensic atom se. They are not intended for use on anything but dji however i measured them and sure enough, got 15 minutes of flying in with a set and they work perfectly. And they're half the price of the Potensic blades. I don't think anyone (i've found anyway) has even mentioned cross compatability in drone blades but i can 100% confirm they are a perfect plug n play swap *ONE NOTE: You must use the included screws with the blades. The screws do NOT swap between the Potensic blades and these dji blades. They come with 16 screws though so this is really a no brainer. I'll update if anything goes wrong but so far it's clear that theyre the same at half the price