HGLRCELRS 2.4GHz ExpressLRS RX Nano Module High Refresh Rate

This prodcut looked too cheap... So I bought it! and so far it looks nice, but one thing that they could improve is add a lttle thingy on the plug (on top) that would clip onto the other plug on the reciver, which would do a better job on holding the wire on, (the wire unplugs very easy) also maybe better packaging than just puting the elrs into a plastic bag but it is 13.99 so I guess its ok. The size of the little thing is small because well... Its a reciver, Im gonna guess the durability is good (with the little rubber/plastic thing) without the thingy im gonna guess its probably gonna break with one crash.

Worked good to convert my mob8 to elrs

It tiny, and even comes with the heat shrink tube. Long and short antenna included which is nice. Elrs firmware was easy to update. Great price for what it is.

Thus receiver is amazing ,elrs is so easy to use, and I like how there are 2 different length antennas.

Great value product, only complaint is it's easy to disconnect the plug (even when padded between two layers of Alien Tape) so you may want to direct solder these on both ends.The size is absolutely tiny, like it'd fit on the tip of my pinky. If I needed a ELRS receiver in my hand it would be this one. Probably be great for a tiny whoop setup IMO, though I'm not sure about the weight.Nice that it comes with 2 dipole antennas. One short one longer.QQ...The colors in the wiring diagram do not match the plug you get so make sure you wire it up correctly. The wires are yellow white red and black, only the red and black correspond to the diagram in the manual. I inadvertently thought the yellow would match the diagram also, but it's deceiving and does not. The yellow is green in the diagram and the white is yellow in the diagram as seen in photos.I guess it's too much to ask to have matching colors to the diagram. After all, FPV gear makes everything harder.

I never had issues with ELRS until this RX. I’d recommend going with the EP1 instead. I had complete rx loss and failsafed in parking lot. I don’t know why I thought I’d trust an HGLRC rx as I’ve never trusted any of their other products.I bought another one of these just for the antenna with no intent on using the Rx, but the ended up needing one. I flashed firmware back to 2.5.2 then to the latest I tried turning model match on and off, reset the module match number, made sure mode match is off in the radio as all my RP1s don’t use it. I even tried swapping rx and tx wired just in case it was mislabeled. No matter what, no inputs to the rx. It binds to my controller but does nothing. It’s cheap because you’re only buying antennas, the Rx doesn’t work.

The receiver works great, but I initially thought it was DOA because I had used the original cable with the connector cut off of one side and soldered to the FC with red to +5v and black to ground. Turns out, red and black are TX and RX and the yellow and white wires are power. Nothing was damaged thankfully. If you cut off a connector and reuse the original cable, beware!

Works well and easy to install, if you need it for a Pixhawk 6x maybe you will need to find another wire with the same input as your Pixhawk and just weld both wires, it works for me.