4 Pack Hall-Effect Joysticks Replacement for DualSense PS5 Controller, 3D Analog Sensor Wheel Thumb Sticks Joystick Rocker Module Replacement for PlayStation 5 Controller

Just finished replacing all 4 joysticks on both of my controllers and right out of the gate, they work great. I highly suggest plugging your controller into your laptop and calibrating it at https://dualshock-tools.github.io to ensure you have it centered properly (very easy process).If you dont have a soldering workstation, you will need to make sure you get the essentials before attempting this replacement. It takes a moderate amount of dexterity and know-how when it comes to removing the old joysticks, desoldering, and soldering in the new components. I wish I had a desoldering gun for removing the old joysticks because using a focused heat tool and desoldering wick was a biznatch.At minimum get yourself a desoldering gun, a soldering iron, solder, and flux before you get started. Doesn't hurt to have some 90% or higher alcohol available to clean the circuit board if needed.Great product thus far, hope it holds up and myvcontroller drift stays a thing of the past.

works ok, makes it a little more touchy though so you might want to lower your sensitivity after

Work as expected for a PS5 controller that was previously experiencing drift. 3 of the 4 would have been fine with no calibration, but one was drifting slightly in game play. Went online and calibrated them on DualShock/tools.github.io. A few other reviews had mentioned issues with their R3. In my case, no issues with my L3 or R3, they still work fine.Removing the existing hardware is a pain, in part due to the number of pins involved and the fact lead free solder requires a higher temperature. After spending too much time trying to desolder ~14 pins and remove as a whole assembly, I ended up breaking it down into smaller parts. For example, disconnected a pot and removed just those 3 pins. Much easier doing it in small steps. Once I got the hang of that trick, the second (left) one took half as much time as the first (right).A nice small flush snippers, desolder braid, and flux are the accessories you need - in addition to a soldering iron and solder. If you don’t know what those are, then this project probably isn’t the one for you.

the sticks worked at first but now it has started drifting after one week. low quality product that is breaking down fast.

They worked great installed on a stick drift controller and once calibrated controller worked with no issues

these sticks are decent for what they are but they have over range issue giving me an error rate of 10% and this cannot be calibrated out they include these shaft wraps and u need to use 2 on each stick to get the circularity to be even and get the error rate down to 5% but that ruins the feel and make them feel sticky i would not recommend these are definitely the ginful v5's stick more like v1'sthe 8% is with the wraps and the other is without

The kit is perfect!All of these were darn near spot on for center calibration right out of the box.Installed all four in my controllers.They feel very nice.Very pleased!

Amazing solution to fix stick drift on the PS5 controller. Knocked one star off as one of the joystick had a different "click" and feel to it when pressing down on it. I only realized this after going through the whole process of installing it. So now I am just going to live with it