Klein Tools 89552 Hole Cutter, Adjustable Cutter from 2 to 12 Inch, Cuts 24 Gauge Steel and 26 Gauge Stainless

I was skeptical......but it worked flawlessly......excellent tool!

Worked great to make circle cuts in ductwork.

Great tool, works perfectly, still in use, will buy again when needing to replace.

This worked ok like a Klein tool but seemed to cut slower then I would have expected. I cut 5 - 10" holes and it did cut consistently the same. The speed of cut could have been due to the speed of the drill I was using. It's a solid tool like most Klein.

This is a great cutter for sheet metal and plastic. That’s what I’ve used it for so far without issue. It works great with a variable speed battery powered drill and I think it’s a great deal for the low price.

the tool is pretty solid but the bits are not that good used 1 bit 12 times than dull started to use the 2nd bit today cut out 2 circles and the bit snapped have had this roughly 3 mo and not buying the bits for it to expensive so basically a junk tool

High quality item, drill bit cuts very quickly and comes with a spare.

I knew I had to cut 8 new 6" duct takeoffs for my finished basement and I was not looking forward to it. So I went looking for a tool to reduce my likely frustration. I did not want to spend a ton since I was going to be doing this hundreds of times, but I wanted it to work. I think this tool hits the sweet spot of cost vs performance. It is simple to use and takes about 2 minutes or so to cut a hole. It makes a super clean hole, with only the last 1/8" or so needing to be cut with a snip tool (or bent back with pliers). Its also nice that the tool helps keep your hand away from the cut edges. Would buy again.

So helpful in making big duct holes. So helpful on my job as a duct cleaner. I broke the first bit at first use, but has been using the second that came with the package for almost 6 months now.

What a cool tool! Cuts perfect circles in tin for covering up abandoned plumbing cans in parkade. When using the tool don’t force it or the bit will break. Just let the tool do it job and you’ll be happy with this purchase

Works pretty well. Buy a spare drill to him with it so you don't run stuck if the included one breaks (like mind did). My fault though. I was pushing the limits of the thickenss of the metal.

Seems to work very well as I tired it for the first time recently. Nice smooth cut and not a lot of effort

So far it’s been great, I’m using it for work on hvac rough in’s. It’s definitely cutting it.