EWAYSafety Backup Rear View Camera for Jeep Wrangler 2007-2018 Reverse Reversing License Plate Camera & for Jeep Wrangler JK Backup Camera Video in-Dash Radio Wire Input Harness AV Plug to Display

Just finished installing on my 2015 Wrangler Unlimited Sahara with automatic transmission and the factory 430n RHB navigation stereo.Install was pretty straight forward after watching numerous videos on YouTube. The image is about 20 inches off center because the camera is mounted by the license plate light, not in the middle of the Jeep, but that’s okay as I was just looking for clearance when backing up.Connect black wire to ground and red wire to positive on back up lights (white wire with gray stripe). Ignore the red wire coming off the video cable. It isn’t needed. Make sure your connections are solid or you will get a black screen. And, take off the protective film on the lens or the image will be fuzzy.Recommend JScan app and the vGate iCar Pro OBD to flash the system to activate the camera in the 430n RHB radio. Much cheaper than the dealership flashing the system.There is more than enough video cable to run from the stereo to the camera. You wil need the adapter that plugs into the back of the stereo for the video cable unless you already have one. I did not realize this until I started my research.Overall, very pleased with purchase, install, and product.

Went in easy, worked great but it must assume its been centered on the rear tire rather than at the license plate frame. Objects on the passenger side appear farther away than they actually are when backing and this creates kind of a "blind spot". This may not be as big of issue without the backing grid (as its off center) but you'd loose your depth indication without. Sadly, no other option when using a tire cover.

Install on my Jeep:1. Remove driver side tail light and License plate light cover/housing2. Swap license plate light housing with new housing and camera, run wires up behind tail light and make a notch in the bottom of the tail light so you don’t punch the wiring.3. Off of the tail light wire harness connect the red camera wire to white wire with gray stripe4. Connect black ground wire from the camera to the black wire of the tail light harness.5. Fish camera video wire through the rubber gasket between the tail light harness channel into the interior of the jeep by cutting a small hole in the rubber plug with a razor blade6. Run video wire under carpet to the dashboard of thecar.7. remove dash trim for radio and fish video wire up to the radio housing8. install Wire harness and connect the video wire and electric tape them together so they don’t disconnect over time9. Ignore the red wire (it’s for a manual transmission) and electric tape it to the video wire10. Use the OBD2 scanner with the OBD jscan app and licences to enable the camera.11. test by putting the car in reverse12. close everything up and enjoy

Works great just have to adjust for off center

Está enfocada en ángulo recto y hay que adaptarla para que encaje bien en su sitio. No lo recomiendo

Could not follow instructions(garbage.) Went to YouTube to find it and all they have is the spare tire mount one not the license plate one. So try to follow it as close as I could Nad I get nothing. Not plug and play. I'll try something to get it to work or if not I'll just eat the cost of it sence it was that cheep.

Camera serves it’s purpose but the image cual it’s is a little bad

Your product isn’t plug and play. I had to spend an additional $129 to make your product work. Your help was an absolute insult. Please note you are an absolute embarrassment to your advertisement of your product!