🔗 Connect with Confidence!
The VSDISPLAY 30 Pins eDP Signal Cable is a high-quality connector designed for a range of eDP LCD screens from 11.6" to 17". With a length of 250mm, it ensures optimal installation flexibility while supporting high resolutions of 1366x768 and 1920x1080. This cable is perfect for anyone looking to enhance their display setup with reliable performance and dedicated customer support.
L**Y
Exactly What I Needed
I needed this cable to repair the back glass of a virtual pinball machine. It lined up perfectly and the machine works like new. (I thought I may have to throw out the entire machine.0
J**N
Perfect replacement for my Arcade Legends Pinball
This was a perfect drop-in replacement for the cable that goes from the VIBS board to the backbox display. Actually, it's a better replacement as the length lets you move the board to somewhere a little more easy to secure in the box.
A**3
Works perfoctly, but is quite fragile
This ribbon cable worked perfectly to connect an old laptop display to my LattePanda Alpha. The only thing to be aware of is that this ribbon cable is extremely fragile, and I ended up breaking the first one I ordered by bending it a little too far.
M**E
Perfect Replacement 30-Pin eDP 1.3 Cable For An LCD Panel
This is the perfect replacement for a 30-Pin eDP 1.3 cable that directly interfaces to an LCD panel.
J**B
Not a replacement for the ALP HD virtual pinball table.
I believe you need a "type A" edp cable for the Atgames Legends, just know this isn't the right one.
J**E
This cable is *noisy*
Bought this for a homemade board that needed to talk to an embedded DisplayPort panel. The cable is of good quality, but there's no shielding or any attempt at noise reduction so it only barely carries a DP signal. Had to be holding it for any picture to appear.
D**L
Works, but...
Bought this ribbon cable as it was recommended to replace the stock cable in the ATGames Legends Pinball.This is used to connect the stock backglass to the either the vibs (if installed) or the machine.The connector on the plug end is upside down, causing the connections to be reversed when installed. I tried to figure out a way to flip it over and plug it in, but it wasn't happening. Ended up breaking the first (good thing you get 2).I was able to get it to work by taking the silver connector end and folding it in half so there were connectors on both sides.Once this was done, I was able to connect it properly and it worked.It's a shame that the cable requires this, and I'm not sure if it will last, but for now it's working.I don't know if there is an alternative that is manufactured correctly for this but there needs to be.
R**D
cable
cable for laptop screen and came quickly in mail.
